Printing on tape

go to your browser search box type Instruction manual for Canon P27 -DH 12digit mini desk top printing calculator . on the page that appears you will see a PDF OF THE INSTRUCTION MANUAL. on the machine lift lid and the ink cartridge can be seen , you can lift the ink cartridge out and replace . Suggest download PDF just in chase .

Your calculator is beyond repair. You can use it in no print mode ohly. The printer is not working, causing the error code.

Turn it off and back on and only use the display mode.

Hi

Please try to add or set up the printer again and set it as default printer. and then try to print the test page.

If not, remove the cartridge and rub the print head into a plain paper with alcohol until inks flows on the paper. Return the cartridges and run the print nozzle for 2-3 times. Then try to print again.

Please let me know if you need more help. Please rate my solution if it helps you or might help others.

Install paper roll with end coming up from rear. Insert end of paper into slot at back of calculator until it stops. Then press feed button until paper advance thru slop at top.

Try cleaning the cartridges after turing the printer off then try again.

turn it off & back on & that should fix it. the ribbon lift needs to reset.
dennis

Hi

Chances are the nozzles are clog. You can send it to a service center for repair or if it has warranty still call manufacturer.

Hope this helps

Hi please try these steps:::

Right-click the printer icon, and then select 'Properties'.
2. Click the 'Maintenance' tab, and then click 'Deep Cleaning'.



3. Select 'All Colors', 'Black' or 'Color' for the print head to be cleaned.





4. Read the message displayed, and then click 'OK'. The power lamp blinks and print head deep cleaning starts. (Do not perform any other operations until print head deep cleaning is complete. Print head deep cleaning takes about 1 minute.)

IF ABOVE STEPS DOESN'T WORK TRY THESE STEPS BELOW

Check ink tank vent hole The ink tank requires air to flow through it so ink can move from the reservoir to the print heads.

1. Confirm there is no orange tape across the top of the ink tank
   
   
2. If the orange tape is as shown in Figure (1), it is properly removed.
   
   
   
   *BCI-3's shown in this example.
   
   
3. If the orange tape is as shown in Figure (2), remove the remaining tape to the level shown in Figure (1).
   
   
4. Make sure each ink tank is snapped into the printer.
   
   IF THESE STEPS DIDNOT WORK THEN YOUR PRINTER NEEDS REPAIR(You might need to change the printer head.)
   

try to move switch into p. or print position

Clean the heads, printer is not reading new cartridge or refilled cartridge. You may also have a paper jam if alignment is affected. Check for little jams, post back if no go lilacgerry xxx