Error code e-218 in canon ir 8500 - Canon Office Equipment & Supplies

Question edited for a LOT more clarity.
Question moved to make model category.

You need a service call. It's not good!

Canon IR2200 error code E000677-5802 - Copytechnet

https://www.copytechnet.com > ... > Canon
Dec 21, 2011 - Re: Canon IR2200 error code E000677-5802 ... Either install the correct Boot-ROM chip or flash the MN-Cont with the correct version of firmware.
Error Code Canon ir2200 e-000677-8502
Dec 15, 2012
ir3300 e000677-5802 - Copytechnet
Feb 23, 2010
Canon IR 2200 Error code 677-5802 - Copytechnet
Mar 11, 2009
More results from www.copytechnet.com Missing: ir7200 ‎' Must include: ir7200

Error E000677-5802 I order a new hard disc and install it - Fixya

https://www.fixya.com > support > t22944758-error_e0...
Nov 19, 2019 - the error refers to PDL board mounting error- suggest if the machine has been moved or if any parts have been removed or replaced you check ALL pwb board ...
How to remove erro 000677-5802 in canon ir 2200
Nov 15, 2019
Canon ir 8500 error code e000677 5802
Nov 29, 2019
e000677 5802 Questions & Answers (with Pictures)
Dec 11, 2019
Canon MY Garden Internal Error
Sept 2, 2019
More results from www.fixya.com Missing: ir7200 ‎' Must include: ir7200

Canon iR3300 - Error Code - Printcopy.info

https://printcopy.info > brand=Canon
Code: E677-0001; Description: A fault occurs it the combination between any of the printer boards (accessories) and the main controller PCB ...

..

Hi. That error means there is a malfunction in the scanning unit . Maybe is the scanning lamp

please find the ir 8500 error code e000111 00000 please help me

hello
8500 IR copy machine
E00015 - 0000 errors.
Please guide me.
I also translated by the site you have to translate the sentences. So you have the goodness wording is easy.
Thanks

E000220-0000

Error E354 in Canon iR 2016
error e354 code appear when you replace PCB controller board.
Please note. Before replace your PCB board with other one.
Pull out a small (FRAM COUNTER) chip from your old PCB board you can found it right side of the PCB board near a battery cell the chip attached with screw open screw and pull it out and attached it with your new PCB board .install your PCB board in the machine and turn on power error e354 will go off.

The front aligning plate home position sensor (PI7) is faulty. The front
aligning plate motor (M4) is faulty. The finisher controller PCB is faulty.

The error code E007 is a fixing film error code > it will have to be replaced to clear the code. That is if it a IR-2020, a IR-8500 does not have a fixing film.

You can start by downloading this software, a new driver dated April 7, 2009
canon driver for the ir 8500

eo 732 is a reader board error or a bad or missing connector from the scanner to the machine looks like a parrallel connector