20 Most Recent Canon imageRUNNER C3220 Color Copier Questions & Answers

Hello. The FF is a hexadecimal number that means the rip did not boot properly.There are buttload of reasons why this my be but lets try this. Power off the copier and the Fiery emulator (rip).Power on the copier only and let it reach aready condition.Then energize the rip and watch the same display that showed the FF.It may take a minute or two as it goes thru its boot/diagnostics,but we hope you dont get the FF again.Now I am assuming that what we are talking about is a previously configured system that had been working fine until recently.If this is so,and the rip does not operate correctly after the directions I just gave then you probably need to re-load the rip's system software.

Canon... | Answered on May 29, 2020

Unfortunately you need a tech, unless you are a handyman.
there is a problem with the fuser,
either the thermistor ( heat regulator)
the thermofuse ( fuse)
or the heat lamp has gone bad

Canon... | Answered on Oct 23, 2019


Canon... | Answered on Apr 08, 2019

you must give clear all in log settings....

Canon... | Answered on Aug 29, 2017

wrong site need to notify your tech dept or your supervisor

Canon... | Answered on Jul 29, 2017

your yellow drum unit is bad replace it if the error ship to 000020-02b0 replace all your drum unit because all the units could be bad but the machine will show one at a time as you replace the drum units

Canon... | Answered on May 02, 2017

this problem can sometimes cause by uncalibrated machine upon replacement of major parts such as assemblies. or parts related to fusing, developing of drum related parts

mis registration of colors can appears if you machine isnt calibrated nor cleaned correctly, try going throug a resetting or set up procedure from your maufacturers manual

this would surely resolve your problems

Canon... | Answered on Jan 29, 2016

This error indicates that it cant detect the scanner unit of IRC3220

Check the cable that connect the machine and scanner unit .switch off the machine disconnect the cable and reconnect it and switch on the machine again hope this will help

Canon... | Answered on Jan 08, 2016

You have a high-voltage leak to the transfer corona. This could be due to several different things, usually it's a dirty corona, maybe excessive dust or toner in the corona assembly. Toner conducts electricity and can leak voltage from the transfer corona to the frame. It may also be the "end-blocks," the thing in the back of the machine into which the transfer corona plugs when you close the drawer and lift up on the green handle. These crack and can cause intermittant failure.
I would start by taking a can of air and thoroughly blowing out the corona assembly and see what that does for you...

Canon... | Answered on Oct 26, 2015

Is it displacement ?

you can try to press user mode * and then selet adjustment / Cleaning and follow it instruction. it will auto fix the problem,

Canon... | Answered on Nov 06, 2014

pls check the error history may be the error

Canon... | Answered on Feb 17, 2014

Not finding what you are looking for?
Canon imageRUNNER C3220 Color Copier Logo

285 questions posted

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment & Supplies Experts

old marine
old marine

Level 3 Expert

2288 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers


Level 3 Expert

13434 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Canon Office Equipment & Supplies

  • Canon Office Equipment & Supplies

Most Popular Question

error code e000732 0001

  • Office Equipment & Supplies