Windchaser Heating & Cooling - Recent Questions, Troubleshooting & Support

I have the exact same problem. No owners or assembly manual. Can get no response from company?

need model number as there are several different model numbers.

blowing good but not cooling

Hi, if it trips the reset, you have a short in some part of the unit. Could be the motor, or several things that would cause this. It can be repaired if you take it in to a appliance repair shop. You know as well as I do it may be a minor problem or major, and its the labor that will get your $$$. Get a estimate and compare to a new unit. I hope I have been of some help to you.
Sincerely,
Shastalaker7

either compressor overheating or low on freon cannot recharge

Most electronic devices have power to the main control board when the unit is plugged in regardless of the switch being on or off. If that is the case and no other issues exist, it is nothing to be concerned about.

Home Depot!

I didn't see the manual when I searched, although there were other manuals. I saw the following article that may be of use to you. https://homesteady.com/how-7511194-operating-instructions-windchaser-pacr10.html

Try any fw webb

"Removable filter basket lifts out for fast and easy filling"

Sorry we do not have parts here, nor do we have any locator service for parts for anything

It probably is not worth trying to salvage it, which is the reason you received a refurbished unit. It would really depend on what is wrong with it. Unless you are trained to handle refrigerant, I would recommend you not trying to mess with the compressor.Unless it had a leak, it should be under pressure, which could hurt you if you attempt to open it up. As far as the rest of the system goes you may use parts off of it to make repairs on the refurbished unit, should the occasion arise, providing it is the same model.

sounds like a blockage in the refrigerant circuit, the compressor is shutting down, protecting itself. possibly the compressor is overheating, possibly it's overcharged. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Need manufacturer model and serial numbers

Eithee the filter is dirty, coil is dirty, primary pan is dirty or the tube or drain is clogged. It needs a good bath!! If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Yes, it definitely requires venting via an exhaust hose(s) (flexible duct) connected to a window converter.

Thanks for choosing FixYa.