Error code e000061 0001

Over heating.

The LL error code indicates "Large Load Detected". If the load is not too large and you have taken some items out and it still comes up displaying the error code "LL" it may be caused from a friction issue. It could be the spinner support with bearing causing the code if it's creating enough friction. You did not indicate if it has any problems with draining water. If the washer is not able to drain completely it could also cause the "LL" error code.

Hello warnerperry6 - Based on the symptoms you are describing the unit could possibly either have a faulty User Interface Board or Main Control Board. You may try and reset the washer by disconnecting the power to the unit for up to 30 seconds by flipping the circuit breaker off and back on. This often clears most false error codes. If the error code persists, it would be advisable to contact an experienced appliance repair tech to assist further.

press the [shutdown]key. After the machine has been shutdown turn the main power switchon the main units right side
[shutdown]
if the machine still does not operate normally contact your service representative with the error code below
E000025-0001

The error code your gettting E000020 is a drum code (imaging unit). You however do not have the complete digits after the E000020-????. Those digits define which drum needs to be replaced. You don't need to go into service mode to clear the error. You only need to buy the correct drum and put it in with the power off. Once it is replaced and the machine is turned on it will register and clear its internal error code. To help, here is what the ending codes mean. The xx's have further meaning but in most cases all roads lead to the same result (replace drum imaging unit).

-01xx yellow (Y)
-02xx magenta (M)
-03xx cyan (C)
-04xx black (K)

Enter into the diagnostic mode.Press 50 then green button,press 20 then green button,press 00 then green button.Switch off the machine & Switch On.

Please advise me on any recalls and technical information involving error code 3E during a wash load, which appears related to be a faulty control panel. My machine is always shutting down each time it reaches the rinse cycle. Numerous consumers have been complaining about this same model at consumeraffairs.com. Replacement of the control panel is expensive at an average cost of 298 dollars and appears to be the corrective action for other consumers with error code 3E. Over current is not being detected at the motor. I'm disappointed with the quality of this washer considering I purchased it in 2005 for over 1,000 dollars. This problem has forced me to use a local laundry mat to wash my clothes. This error code is not listed in the User manual.

check the water level switching or door sensor

Had the same problem with an ew26ss65g50. unplug the machine and let it defrost. then plug back in after an hour or so. problem is the evaporator fan gets iced up from water spilling in/on it and air does not circulate. makes a horrible grinding noise before it shuts down. anyway, my icemaker is off right now and that solved the shutdown problem. working on repairing it.

Just restart the system and turn off the printer and turn on the printer it will work.

Check did you correctly placed your cartidges.