How do I remove a Jensen jrv9000 from my Ford 450 dash

Generic Ford help, nothing specific to E-450.

https://www.google.com/search?q=2013+Ford+E-450+Remove+glove+box

..

Hi.

The Jensen XS-1010 is a 450-Watt 10" (450W peak, 150W RMS ) Subwoofer.

Below the full technical specifications:

Tech Specs

Product Type - Car subwoofer driver

Dimensions (WxDxH) / Weight - Car subwoofer driver : 4.7 in Diameter 10.1 in

Dimensions - Diameter - 10.1 in

Enclosure Color - Blue

Localization - English

Speaker Type - Passive

Speaker Diameter - 10"

Nominal (RMS) Output Power - 150 Watt

Max (RMS) Output Power - 450 Watt

Response Bandwidth - 24 - 1000 Hz

Input Impedance - 4 Ohm

Output Level (SPL) - 88 dB

Connectivity Technology - Wired

Speakers Included - Car subwoofer driver - 10" - 150 Watt - 24 - 1000 Hz - 4 Ohm - wired

Driver Details - Car subwoofer driver : 1 x subwoofer driver - 10" - polypropylene - Mid-Q

Diameter - 9 in

Depth - 4.4 in

try audiovox.com. Audiovox owns Jensen.

2001 Ford Truck F450 Super Duty P/U 4WD 6.8L EFI 10cyl the Flasher is located front seating area, driver side, under dash, mounted in fuse panel.

Also can check your 2001-Ford-F-450-Owners-Manual (page 170 and next for Fuse Description).

TY for using Fixya; hope this help (remember comment and rated this).

if im not mistaken i you have to pull your dash off then behind the dash you will have about three or four screws holding your radio in place after removing those screws you should be able to take your radio out as far as puling you dash you will need to look for about two screws usually on the bottom if not the check in to make sure before you go yanking on your dash that you have removed every screw so as you dont break it

First check the wiring to the radio. You may measure the power being ok but you also need to make sure the ground connection is ok. If this is all ok it may be that you have dry solder joints on wiring socket inside the radio or a blown track or protection diode.

yes,pull the bolts off the axel,pull out but there is also a tool to remove the hub and bearings-a large socket with 4 tabs on the end

The Fuel pump relay is in the Power Distribution Box under the hood, it is relay K. If it is the fuse then fuse 17 in the PDB.
It could also be the cut off switch, which is either under the dash above the brake pedal or behind the passenger kick panel

Hi....there are spring clips that hold the dash bezel to dash. Carefully pop the bezel out (a small flat tip screwdriver would work well) and there should be 2 screws (or spring clips) that secure the switch to the bezel. Remove those, then the switch and reverse procedure for installation.

Chris

just take out the whole dash kit and then you will be able to take it out