20 Most Recent Jensen JX1200 Car Subwoofer Questions & Answers

0helpful
2answers

Smoke coming out of subs

If smoke has come out of the subwoofer, the speaker itself, that means the voice coils have been heated excessively and they are damaged or in this case, I'd say completely blown. Voice coils blow because they've been driven too hard, too much power, too much distortion for too long.

If you can get access to the front of the subwoofer speakers, gently put even pressure with your fingers near the middle of the cone, just around the edge of the centre dust cap and push gently and slightly inwards. If you hear or feel a "scratchy" type sound or feel, or if they dont move in freely, they are blown. And if that's the case, your amp could be damaged as well.

Most modern car amps have circuit protection and will shut down when they detect a load greater than they are used to so the amp MAY be ok. One way to test the amp is to hook another speaker to it, any speaker as a test is ok, and see if sound comes out. Make sure all power is off when connecting and disconnecting speakers!
1/17/2018 1:36:32 AM • Jensen JX1200... • Answered on Jan 17, 2018
0helpful
1answer

What type of speakers i need for a 4000 watt planet audio

good ones check with web site robotunderground.com
1/20/2014 6:45:19 AM • Jensen JX1200... • Answered on Jan 20, 2014
0helpful
2answers

Jensen CAR1000 brake bypass?

Ground the parking brake wire
3/21/2022 11:29:34 AM • Jensen Car Audio... • Answered on Mar 21, 2022
0helpful
2answers

I have a Jensen stereo cd/dvd player and when I load a cd or dvd into it constantly is loading and doesn't proceed

I used to own Jensen cd player for a while but I can't remember the solution of loop loading. Check Jensen cd-players manuals http://jensen.manymanuals.com/cd-players
11/21/2020 5:05:18 PM • Jensen Car Audio... • Answered on Nov 21, 2020
0helpful
1answer

Jensen vx7022 head unit for car i was updating firmware and it got to the calibration screen and wont go any further no my unit doesn't work at all please help

There is always a chance that you "bricked" the unit with the update. IT happens. When you get to the cross hairs you are supposed to hold your finger in the middle till it asks for the next step. IF it wont go to this, then can you retry the whole process over again. If not you have bricked it and it has to be sent in for reflash
11/10/2020 5:02:31 PM • Jensen Car Audio... • Answered on Nov 10, 2020
0helpful
2answers

Does the Jensen UV 10 stereo have internal fuses that can be replaced

In the back of the set you should find a small 'spade' type fuse, replace with Fuse: 15-amp, mini ATM type There is a fuse holder in on the yellow wire on the wiring harness, pull out the unit and replace fuse. User manual: http://www.jensenmobile.com/docs/common/UV10/UV10_OM.pdf Wiring diagram http://www.manualslib.com/manual/674477/Jensen-Uv10.html?page=4#manual Good luck.
8/6/2020 3:32:08 AM • Jensen Car Audio... • Answered on Aug 06, 2020
0helpful
6answers

How to bypass jensen

I just purchased the VX7020 and went to Settings-Language-typed in 5,4,3,2,1,0 but the menu never came up. Any ideas?
5/20/2020 11:25:04 AM • Jensen Car Audio... • Answered on May 20, 2020
0helpful
1answer

Jensen eqa-110 speaker wiring?

This info is on the bottom of it.
3/15/2020 12:19:31 PM • Jensen Car Audio... • Answered on Mar 15, 2020
0helpful
1answer

Hi, I have a Jensen JCD 233u car radio, I've tried to connect the power on it but I fail, these only four power wires behind, ground, auto antena, memory and 12 volt positive wire, Please help how can I connect it ?

Ground - negative
12v positive - switchable positive (for example, on when ignition is on, usually connected to accessory side on ignition switch)
auto ant - connected to your electric antenna or to turn on external amplifier.
Memory - connected to always on positive (to keep all your stereo presets )
2/11/2020 1:18:39 PM • Jensen Car Audio... • Answered on Feb 11, 2020
0helpful
1answer

How to get to the advance setting on a je1911 jensen

YOU HAVE TO GO INTO THE MENU SETTING
9/12/2019 4:52:19 AM • Jensen Car Audio... • Answered on Sep 12, 2019
0helpful
1answer
0helpful
1answer

I have a jensen jdvd-dd7 and the screen is not sliding when pushing eject only a bip sound. When push angle shows a no entry or prohibited sign

Ribbon from player to screen not properly connected or broken due to unfolding and folding.
7/17/2019 2:06:00 AM • Jensen Car Audio... • Answered on Jul 17, 2019
Not finding what you are looking for?
Jensen JX1200 Car Subwoofer Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Top Jensen Car Audio & Video Experts

ZappaNut
ZappaNut

Level 3 Expert

960 Answers

xxxxxx xxx

Level 3 Expert

5033 Answers

 Francisco Mauricio...
Francisco Mauricio...

Level 3 Expert

1551 Answers

Are you a Jensen Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Jensen Car Audio & Video

  • Jensen Car Audio & Video

Most Popular Question

smoke coming out subs

  • Car Audio & Video
Loading...