Fujitsu plasma tv connection problem

The problem must be with it connections you have done. Contact any service technician. Do not make any experiments. Remember; it's a plasma TV. Gopakumar Gopalan Google

check connections most likely culprit is a blown fuse on the screen mainboard very easy to replace but must be soldered unless you use a little bit of copper wire twisted and rolled up to cover both ends of the internal fuse then stick it down with insulation tape but do this at your own risk

If you already checked the connections then your backlight just went out on it

Hi,

It sounds as though you have a fault on the Power supply, the fan doesn't not normally fail on this model. If you'd like your screen repaired, please call 0208 731 3432

A user manual is available from this link:-
http://safemanuals.com/user-guide-instructions-owner-manual/FUJITSU/PLASMAVISION%20PDS4221-_E
Check for a hidden power switch under the lower left or right under corner of the screen, ensure it is ON (- not sure if this switch is fitted to your model, but it does exist on other Fujitsu models).
Fujitsu no longer support or manufacture plasma screen TVs - therefore no parts are available from them. [Fujitsu only serviced to board replacement level - very expensive].
The Fujitsu models (generally, after 4 or more years use) suffer from cracked solder joints on circuit boards (due thermal cycling stress).
See Fixya tips:-
"Fujitsu Plasma 42" random shutdown - continuous flashing red led".

Take a SCART lead and connect the output from the SKY box and connect to anyone of the SCART sockets on the TV. Alternatively take the digital out from the Sky box to a digital input on the TV. The necessary connection wires can be obtained from most TV Retailers, Electrical Chain Stores, Some PC dealers, online at eBay, etc. Direct Digital connection will give the best quality picture and if you use a SCART cable then make sure it is high quality thick shielded cable and gold flashed connectors as there are many inferior products out there.

This is most likely caused by the Main Power pcb.

See Fujitsu Service Bulletin on this problem in a similar model from Fujitsu. -see link below
http://tomtom2k5.free.fr/fujitsu/PDP-0035-06.pdf

A competent service technician should be able to implement the service bulletin.
A similar service bulletin is probably available for your model. Request bulletin from Fujitsu '[email protected]'

Try this website for free download:-

http://www.retrevo.com/samples/Fujitsu-TV-manuals.html

Hi Calif Lady,

For assistance locating a service center for Plasmavision, Fujitsu’s brand of plasma televisions, visit http://www.plasmavision.com/locate_serv_ctr.htm. This should populate a list of authorized service centers.

Otherwise, you may visit http://www.plasmavision.com/service_inquiry.htm to enter a specific inquiry.

Thank you,
Jason,
Go Ahead. Use Us.

yes you can connect airial antenna to your tv! what do you mean by wash? or you can clean your monitor with 100% cotton...