Brother IntelliFax-2820 Laser Fax "fuser" Questions

Ad

Question about Office Equipment & Supplies

1 Answer

canon copier error message "error001" "E000"Low fuser temp. (Heat lamp, thermoswitch, thermistor, SSR) "E001"High fuser temp. (Thermistor) "E002"Fuser temp. too low "E003"Fuser temp. too low

Ad

Question about Panasonic Office Equipment & Supplies

1 Answer

Fuser thermistor fuser unit or lpc board Where the loction of the Fuser thermistor fuser unit or lpc board and how to replace it the fuser thermistor makes contact with the heat roller. Normally they ...

Ad

Question about Brother Office Equipment & Supplies

1 Answer

...won't come out. Not sure what to remove to get to the paper. Can be tricky people usally damage the fuser rollers removing this jam with pliers/tweezers, it has concertined and stuck after fuser ...

Question about Xerox Office Equipment & Supplies

1 Answer

How do I know my fuser is good or not? Getting the error 062-380 on 7345. If the toner rubs off the page after it comes out of the printer the fuser is bad. Fuser wires get very hot, so if the page ...

Question about Office Equipment & Supplies

1 Answer

paper jam in fuser panssonic kxflb 851 fax jams in fuser with 3/4 of paper out of fuser unit Sounds like a timing jam, check paper supply, fanned, good quality, check and clean paper feed rollers. ...

Question about Office Equipment & Supplies

1 Answer

It reads low heat error....what does that mean? This refers to a cold fuser. The Fuser Temperature Sensor may be falsely reporting, but since this is part of the fuser...either way, you will need to ...

Question about Brother Office Equipment & Supplies

1 Answer

fuser melting the roller and "fail to warm up" error found that fuser was melted to the sleeve. installed new fuser and got a "fail to warm up" error. looked at fuser and the brand new one is melted ...

Question about Samsung Office Equipment & Supplies

1 Answer

samsung sf5100 fax shows "fuser error" and I cannot receive faxes but can send ok The fuser unit will need to be replaced. It's possible that the heat lamp or thermostat of the fuser has failed, but ...

Question about Office Equipment & Supplies

1 Answer

hl 4070cdw fuser life end, how do i reset, i am an angineer The fuser is reset when replacing the fuser. Just ignore the message until you can't use the machine any more, then replace the fuser.

Question about Ricoh Office Equipment & Supplies

1 Answer

Error 0548H Ricoh fax 4420L Fuser Error. Check fuser thermistor. reset fuser error. Go to Service Mode press 1 0 7 , clear/stop , 1 copy, 5 mode, ok, 810, ok, change to 1, press half tone and ok ...

Not finding what you are looking for?
Brother IntelliFax-2820 Laser Fax Logo

993 questions posted

Ask a Question

Usually answered in minutes!

Top Brother Office Equipment & Supplies Experts

CheckitRight
CheckitRight

Level 3 Expert

1363 Answers

James Cagle
James Cagle

Level 2 Expert

482 Answers

Jim Keysor

Level 2 Expert

331 Answers

Are you a Brother Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...