Dyson DC14 All floors Bagless Upright Cyclonic Vacuum "beater brush turn bare floor" Questions

...beater brush. Remove the beater brush and clean off all debris, especially at both ends. You will find a square(?) piece at each end of the beater brush that holds it in place. This need to turn ...

...beater bar turns until the handle is placed into the upright position. What might be the problem? Hi its Darran at Dyson. The brush control is designed to switch the brush bar off automatically when ...

...beater brush and it rotates freely when you hold the plastic end pieces. When it is off I can't find anything binding or rubbing. The self-propel feature works ok, and does not affect this problem. ...

...beater brush is spinning when you tip it up to look at it but slight pressure of it contacting the floor is enough to stop it. If it were my machine I would remove the beater brush and clean it as ...

...beater bar is connected to a tiny switch, if that switch is not operating that could be the problem. If the motor is not spinning, that could be your problem (seized), or if you have a broken belt ...

...beater brush wont spin because the brush roll is always in the off position. Moving the carpet/hard switch doesn't turn it on. Hello : Try this please : Switch the carpet/bare floor dial back & ...

beater brush will not turn. The eater brush on my Dyson animal 14 will not turn. I have had belts replaced and the bar will turn for about 10 minutes and the quit. Please help It MAY be a clutch issue

...beater bar won't turn. I can't find my manual anywhere - any suggestions as to the cause? There is a part under the knob that adjusts from bare floor to carpet that goes bad on these vacuums. I have ...

...turn anti-clockwise, this will unlock the front edges. You should now be able to remove the bottom plate of the head. Once you have the head off, remove any hair and dust you can see, and if you hold ...

...beater bar runs for 4 seconds and then turns off when it is one of the carpet settings. I toggled the bare floor button several times, thinking that the Is there something that I could try? Hello, ...