Kenmore elite dishwasher 665 15962990

Question edited to what I think you thought you were saying.
Question moved from 'Elite Office Equipment'.

Did you press and hold the buttons?

How to Turn Off the Lock Mode on Kenmore Dishwashers

1. Press the "Heated Dry" or "Air Dry" button on the control panel for four seconds until the Lock button lights up with a solid light. ...
2. Note that any button that you press while the machine is in Lock mode flashes four times.

More items...

How to Turn Off the Lock Mode on Kenmore Dishwashers

More here

https://www.google.com/search?q=kenmore+elite+dishwasher+how+to+remove+Control+Lock

..

The buttons must be pressed in the following order: "Heated Dry," "Normal Wash," "Heated Dry" and "Normal Wash." After pressing the buttons, your Kenmore dishwasher will begin a short, 12 minute test cycle and reset the control panel. https://removeandreplace.com/2015/10/26/kenmore-dishwasher-error-fault-codes-led-display-blinking

While the door is closed, try pressing and holding the cancel button for about 10 seconds to see if it will clear.

Unlock your Kenmore dishwasher control panel by pressing and holding the "Heated Dry" button for four seconds.

Press a series of four buttons in quick succession. Press "Heated Dry," "Normal Wash," "Heated Dry" and "Normal Wash" to instruct your Kenmore dishwasher to run a short diagnostic test.

Then you have to wait 2 minutes while your Kenmore dishwasher runs its diagnostic test.

Then press the "Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel and stop any lights from blinking.

You may want to try:
Press a series of four buttons in quick succession. Press "Heated Dry," "Normal Wash," "Heated Dry" and "Normal Wash" to instruct your Kenmore dishwasher to run a short diagnostic test.
Wait for two minutes while your Kenmore dishwasher runs its diagnostic test.
Press the "Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel.
Check to make sure that there's no standing water in the bottom of your dishwasher. Standing water in your dishwasher may indicate that your dishwasher has stopped mid-cycle. You will need to press the "Cancel/Drain" button before you can reset your dishwasher control panel.

try turning breaker panel for that off, and back on. might just need to be reset. If that doesn't work, call the repair man

Hello,

follow the below instructions:

Unlock your Kenmore dishwasher control panel by pressing and holding the "Heated Dry" button for four seconds.

Press a series of four buttons in quick succession. Press "Heated Dry," "Normal Wash," "Heated Dry" and "Normal Wash" to instruct your Kenmore dishwasher to run a short diagnostic test

Wait for two minutes while your Kenmore dishwasher runs its diagnostic test.

Press the "Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel and stop the "Clean" light from blinking repeatedly.
Good luck.

It seems that there is something stucks in your dishwasher...
is there any error code?

silly question but did you try holding the control lock button(perhaps its the heated dry button) in for 3 secs???? sonds as if the CONTROL LOCK has benn activated( child lockout)

press back and forth between hi-tempwash and sani rinse several times to get all lights to come on if not then press sani rinse and heated dry back and forth several times. one of though combos will start the test mode. the test mode will stop the light from blinking and you can use the dishwasher again