Have taken everything I can apart and can not find the pump belt. How do I change it.

The brush is driven by two belts and a clutch. Your belts on the clutch are stretched. Their are several youtube videos for rebuilding and replacing a DC07 clutch. Just change the blets don't buy a new clutch. A lot cheaper to change belts. You might as well clean everything up while you gave it apart. Have fun.

If no response when you put the switch on in the 'floor mode' check the switch. It might be partially malfunctioning.
Check for kinks or holes in the line.

Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101
tiutiu

The reason the water is not dispersing is because the pump belt is probably stretched or worn. You can get belts and view the manual here:

Bissell 1699 ProHeat Belt and Manual

The problem is most likely that your pump belt is worn, stretched or broken. Here you can get the belts you need and view the manual:

http://www.vacbelts.com/bissell-proheat-belt-combo-pack.htm

just taken ours apart with the same problem... found it was caused by the 2 halves of the main casing coming apart in the area where the upright pedal release is. I found this to be due to the upper casing having broken in 2 places - the bottom of the screw wells. This means that the water tank cannot exert sufficient pressure on the valve to release the water. Only solution is a new top cover assembly

its either the power head is clogged up with debree or the belt is broken. if the belt is broken it wont wisp everything up. Take it to a shop to fix. DONT TRY TO FIX IT YOURSELF~!!! dysons are very expensive and arent made to just be taken apart

There should be a belt tensioner for the V belt, maybe it is not contacting the belt when you tilt the handle back. If this is less then 1 year old, then it is under warranty, take it in to a warranty servicer for warranty repair.

If it is completely dead, then either a bad cord, switch, motor, or a broken connection, it will have to be taken apart to find the problem.

This must be a Savvy, Take off the plate covering the brush roll, then take out 2 screws from the bottom, turn it over, remove the Hoover emblem, there is another ***** there. Then the top cover will come off.