Hi, we have a problem with laserjet m1005 mfp where by mistake the language has been changed and i cannot even come to the menu button of "factory setting" to change it to "english language". some russin language has come up in the control panel which unable understand anything. brgds sanjay

You can use the service manual to solve this problem
http://www.nodevice.com/manual/laserjet-m1005-mfp/get83409.html

If you go to H.P's website and go to support imput that you need drivers for your laserjet m1005 mfp. and you will either be able to down load it right away or they will send you an e-mail with it or a link to retrieve one..Good Luck

Hi,

The way was hidden somewhere in the HP solution center:



1. Press the cancel and power buttons at the same time, while the printer is on.

2. Press the blue, green and gray buttons (in this order)

3. Change the menu options with grey button until you get to the "Resets" menu.

4. Press OK. "Country and Language reset" displays.

5. Press and hold OK for approx 2 seconds, then release. The printer will turn off.

6. Start the printer again - it should ask you to select language.

Here is the Driver and Software download page for your HP Laser Jet M1005 at hp.com:

http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?lang=en&cc=us&prodNameId=1839459&taskId=135&prodTypeId=18972&prodSeriesId=1839458&lang=en&cc=us

1. After you click on the link above, select the language for your printer driver from the drop down menu.

2. Select the version of Windows 7 you have. (either 32- bit or 64-bit)

3. Save the file to a new folder on your desktop. (It will be easy to locate after downloading it)

4. I would also download the Windows 7 Print Driver - Installation Instructions save it to the folder on your desktop and read it before you install the printer driver.

PLS INSERT PAPER PROPERLY

My HP Laserjet m1005 mfp is showing error 6, please provide support and help us in solving the error

hi
it means you have a paper jam

open up the tray, take the paper out and place back.

switch off printer and turn back on.

i have just found this on the internet myself and I have struggled for a week, but now ok...

Manish, download the drivers from
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=US&swItem=ma-44776-1&mode=4&idx=1
and burn them to a CD.

your scanunit's lamps frecuenci is changed you should replace the scanunit

Try to perform a soft reset
1. Press MENU/ENTER.
2. Simultaneously press then release the * button and the # button to enter the Developer's
menu.
3. Press the < or > button until the message REINIT FFS appears on the second line of the
control-panel display.
4. Press MENU/ENTER.
5. The process takes approximately 2.5 minutes. During that time, the control-panel display
will change several times before returning to Ready.
6. When the Ready message appears on the control-panel display, press CANCEL to exit the
Developer's menu.