Seems like a line across the screen picture looks like it is smashed and sound is fine

It is an indication that you have a problem on the vertical section on the main board. The faulty parts is the electrolytic capacitor which affect the linearity of the screen that's why you encountered that kind of problem.
I've advice you to send it to repair shop or look for a qualified technician to isolate the faulty electrolytic capacitor and do re-soldering for some dry joints on the main board.Once replaced the capacitor your unit will back to normal again.
thanks for using fixya...

Check solder on the vertical output or change it. Dont know # but look for IC screew on heat sink with about 7 to 14 pins.

Remove the Battery from the Camera then press and hold the power button for 30 seconds. Then, reinsert the Battery pack and turn on the Camera and reset it to the original factory settings by selecting the "Initialize" option under Setup1.

If the issue persists then service will be required.

hoz. out of sny. look for cap 200/100v

Replace c7136 & c7154 on A board This should clear up your problem

Call toll free number for support.

Cheers!!!
Ujjwal B Soni

does any one can send me the schematic of TOSHIBA 32A40? I have a vertical problem and I need to locate the vertical IC or trancistor.
I only see a horizontal line on my Tv.

thanks.
[email protected]

Your projection tubes are messed up. It's a very expensive fix, just get a working TV off craigslist with a smashed screen and reuse your screen itself (usually 100-200$) or just toss the TV and upgrade to an LCD

intermintence in vertical IC deflection its a job for experienced tech need to look for that circuit and do fine job resolding that IC

can you post a picture of the lines that are going across your screen? Sounds like maybe retrace lines.