Lines in picture

There are two reasons for this fault. A fault smoothing capacitor at the video output voltage rail, or excess of screen voltage. These lines are called 'vertical retrace lines' technically. Check this link for more details. It has a post, which have information regarding this fault. Go to older posts there.

That cannot be repaired as the screen on your notebook has layers and between those layers gas is compressed within thin columns. In your case your screen got a minute leak in one of the columns and now that column is unable to produce image. Hence, It can't be repaired. You have to change the entire screen.

yes this could be the start of bad picture tubes . but you can adjust g2 controls and get rid of the line

it's an lcd filter fault it's betwine lamp and screen before mirror, seems like u will need to replace it but it hard to say without look at it.

Hello,
It is bad ccd issue in Canon A95 camera and ccd imager needs to be replaced.

Canon will repair A95 free of cost as per announced scheme.

Click Canon CCD Advisory for details.

Good luck.

Hi I had the same problem. Broken white lines across the top of the screen. This is called overscan. You need to go into the Setup menu, other settings. 16:9 overscan needs to be on. Hope this helps.It solved our problem.

Right click on the desktop, go to Properties --> Settings --> Advanced --> Troubleshoot --> Drag the Hardware acceleration pointer to the left or adjust it then apply...this should solve the problem..

It is not a bulb. It is a picture tube. If there are thin blue lines across the entire screen, not just the edges, and the picture itself looks too blue, it means that the blue picture tube is being driven too hard. This could be because the blue screen voltage is too high, the boost voltage on the blue picture tube is too low, or the video output is leaky or shorted. If the picture has what looks like blue arcs and double images on one or more sides of the picture, it means that one of your convergence IC's has burned out and needs to be replaced. These are things that should be tested and serviced by a qualified tech, so allow an experienced tech to handle it for you.

try to adjust the screen control in the flyback transformer. good luck

my guess ...it fell... sorry! the lines r there to stay unless u'll replace it with new 1