Kenmore 80 series washer will not fill. replaced

is the cold water all the way on?

if so, the first thing to do would be to check the screens in the cold water fill hose and the screen in the cold side of the water valve on the back of the machine. if that is not the problem then replace the water valve.

(turn the water off before taking the hose loose)

Replace the water mixing valve assembly.he part where the hoses attach.
Eric

It means that your machine is taking longer then a specified time (~10 Mins) to fill!! Check your water pressure, the water valves, the little filters in the hose, where it screws into the water and/or machine. Good Luck

Check the solenoids at the water inlet valve for continuity using a multimeter or ohmmeter. A lack of continuity indicates a faulty solenoid.
Hope this helped and best wishes.

it sounds like the water valve is bad,the water valve level(sm. med. lg.)controls the water valce-mike

one of three things,inlet water valve bad,water level hose came loose or water level switch is bad,check all tree and let me know-mike

it sounds like the hot water supply hose on the back inlet water valve is not opening up,to check it switch the hoses,cold on hot,and hot on cold,put the washer on fill cold,if hot water comes out you know it's the water valve-mike

Yes, the only other thing I would do and you may have done this is to put the hose directly over in the washer tub and turn the water on to check the flow. If that's good then replace the water valve.

the pressure switch is inside the console with the timer on top of washer, it is the round thing with a rubber hose stuck onto it ,,, if you have a know that you can set for water level that is it, some models dont have the knob but all has the pressure switch ,,, take the 2 screws out of the console and pull forward at bottom and swing up to get to all the controls, be sure to have your washer unplugged when doing this / larry

Yes patrick you can try removing the cold hose from the washer, look inside the valve for a metal screen. If it has sediment blocking it remove screen, clean it and reinstall. If still no water replace inlet valve.