Whash machine f11 code

if its a Kenmore model then this message says that the button control board has lost sight of the main control board , but its been my experience that this maybe able to be reset and it may never come back or it will not reset and the control board will need replaced (50/50)


cycling power may reset this

After years of suffering from random F11 that became a permanent F11, I did the repair as in the video and all is good for 2 years. No more F11. About one load a day (we have kids!)

F11 indicates a fault with the main control board.
Prepare yourself for a shock when you click on the parts link.



Click here for the part

Hi

Error code F05 means that the pressure switch is jammed on full.
Remove lower rear cover of washer.
Locate and remove the large black fastened to bottom of the drum.
Remove and clean plastic filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.
Hope this helps you.

Hi,

The F11 code means that communication between the CCU circuit board at the top of the machine and the motor control circuit board at the bottom of the machine has been lost. The problem most often found is cold solder joints on the CCU board that make and break causing the F11 code and sometimes an FdL code. To fix this you need to remove the CCU circuit board at the top of the machine and have the larger solder points of the relays and the spade connectors resoldered. If your not to handy with soldering you could just print out this response and a good appliance repair shop should be able to help you out. Good Luck.

My f11 code is repaired! I got a clamp from Home Depot put it on the ccu unit on the right side tightened it shut and haven't got the stinking f11 code ever since. No more banging it again! I can finally do my wash without the horror beeping sound going off every time.

unpug for 30 min, resets ccu

Not sure what machine you have?

F11 Error Code for Whirlpool Duet & Duet HT :

F11 is Serial Communication Error, communication between the central control and the motor control unit cannot be sent correctly.

Check all connectors at the motor control and the Main control, check the motor, check drive system for any worn or failed components.

This is the only F11 Error code I could find for a washer.

its your ccu board under top in back easy to change about 300.00 that is f 11 code "plz"

you probably have a leak high up in the machine. take the top off, wash some blankets and see if you can spot the leak