Have a performa model 53-3540"REL" . Replaced timer but still will not start

Question edited for clarity.

The wiring is here
https://www.partselect.com/Models/PDET910AYW/Sections/WIRING-INFORMATION/?ModelID=177232&ModelNum=PDET910AYW&mfgModelNum=&ManufactureID=1&Selected=59105&Position=6&mfg=Maytag&Type=Dryer&Mark=6

https://www.google.com/search?q=maytag+performa+pdet910ayw+wiring+diagram

.. The video, may be of help

It sounds like it may be the control board itself.

Maytag Performa Mod.PYET244AYW wont start has power door switch good thermo protection good at element cant fin any fuses timer has 120v and selecter switch

Look on the side of the gas vent tube. It should have 2 black wires going to it and a pink dot on it.

I would suggest checking and probly replacing especially if you cant hear the timer motor.

I'm having the exact same problem verbatium! did you ever figure it out. I already replaced the motor and the belt, but it's still doing the same thing.

make sure you reset the lamp timer. Manual has the steps. Hitachi Performa CP RS55 3 LCD Projector

if the timer is reset, try cleaning the color wheel. Optoma HD20 Projector Cleaning this video is for an optoma but the color wheel is cleaned the same way in most DLP projectors. Dirty or dusty color wheel sensors cause the projector to shut down and act like its the lamp.

yes it sounds like a timer fault

some models you remove center cap on knob and pull pin out others you need to remove screws in console and lean in forward to acess rear of timer push knob in pull small pin in back of timer and then pull knob off

There are to devices that can cause this. The lid switch and the water level control valve.