Fast cycle sticks after 17 minutes with NO beeps or alarms
SOURCE: Fisher paykel DD603 top drawer starts cycle then
When it stops and beeps can you tell me all lights that are on when you open the drawer cheers. also check to see if the water in the tub is hot if not you have a heating issue. either a faulty element or Mtr Controller module. try swapping the Mtr Controller module (computer board) from the top drawer to the bottom drawer and see if that moves the fault. cheers
SOURCE: fisher paykel dd603 stops while in cycle and beeps
Does it open the lid?... and does the display flash, as if paused?... if so, just clean the closed sensor lenses, top right hand corner of the drawer, and the little piece of plastic they shine into on the housing.
SOURCE: My 603 integrated keeps stopping mid cycle and
I had the same problem; it turns out that there is a little plastic clip that holds the main circuit board in place and aligns the sensor on the circuit board with a little hole on the unit. This clip was broken and hence the circuit board was moving around, causing misalignment of the sensor and hence the unit would turn on and off during cycles. This may be your problem.
SOURCE: I have a dish drawer DD603 purchased in 2005. It
I presume you have a double drawer model.
Does this problem occur with both drawers?
618 views
Usually answered in minutes!
I need to re word my problem , the machine stops progressing through the cycle but remains running on the wash possition until I have to manually stop it. There is a bit of worm water in the bottom when I open it.
Sorry warm water
Completed the12 min rinse cycle no problem
×