Acer AL1716 Blank screen & blinking green power LED

if u have an extra gpu try it, becuase i hade the same problem and it was not the monitrs fault

buy new lcd bro

Definitely a problem with the monitor. If you can get the back open then look at the main board and the power board. You will want to look for puffy capacitors. Instead of a flat top it will look puffy like its pregnant.

If you find any like that then you need to replace them with new capacitors that have the same Uf rating and at least the same voltage or higher.

This will take some unsoldering and soldering skills. Make sure the stiped edge gets aligned with the striped edge on the board.

If you replaced them then the monitor should turn back on. If it doesn't then its a screen problem and you'll need to get a new monitor.

Look for bad capacitors in the power supply, this is common problem in ALL brand of monitors.
http://en.wikipedia.org/wiki/Capacitor_plague

Might be your graphics card, try swapping it out for a new one and see if that works

When the LCD monitor display flickers and or has a black screen then the fault is usually a faulty inverter or the CCFL lamp. When you look at the screen at a sharp angle and you see a dim image then it is a backlight problem and it is caused by a faulty inverter or a CCFL lamp.
Check out LCD Parts for parts, service, and DIY info. Use this link to their WEB site :-
www.lcdparts.net

Hello,

The problem on your monitor is a bad power supply. Because of heat buildup in LCD monitors parts called capacitors overheat and blow out. You can go to our web site at:
www.ccl-la.com/badcaps.htm and see what to look for. If you open your monitor and see blown capacitors that look like the pictures on our site then replace the bad ones and you should be back going. Email me if you have additional questions or if you need to get the capacitors, we carry them in stock.

I hope this helps, if so please rate my solution.

Buddy
Corporate Computer
www.ccl-la.com

Hi!
I have acer al1716 LCD and whan the computer is turn on, the lcd led turn green but the lcd is showing black, what i can do?

thank you!

my Acer AL1716 monitor will not come on after pressing the on button and no green light.

LOOKS LIKE A BURN SOLDER !! , open the monitor , check the PC BOARD around the transformer area , look for burn spot or cold solder , RE solder it , try again , hope this helps please rate solution and thanks AJ