20 Most Recent
Haier ESD400 Stainless Steel 24 in. Built-in Dishwasher - Page 6 Questions & Answers
The tablets aren't dissolving and
Hi,
I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works like new... However I have also foundthat if the heating element goes bad then that also can mess things up bad...So I would buy new spray arms, and also check out the heating element to makesure it is working... Here is a tip that will help you with the onlinebuying...
Dishwasher
SprayArms not Spinning
How to Buy
ApplianceParts OnlineA bad heating element causes many problems in dishwashers...
Dishwasher Problems The
HeatingElement not WorkingDishwasherMaintenance
DishwasherResidue and Film on Dishes
heatman101
Asker's Testimonial "explanation very clear. will give it a go and see howsimple it was. thanks Ronnie " - ronnieshomes
4/2/2011 10:50:26 PM •
Haier...
•
Answered
on Apr 02, 2011
Dishwasher machine does not fill
1st place I would look is to turn off hot and cold water going to washer,remove hoses and check screens there are usually 2 screens 1 in each connection on washer they pull out and then you can see if they are clogged with debris.After cleaning them make sure you put them back in so that they can protect your washer.
It may also be a good idea to replace those rubber washers in the hose at this time if you haven't in a while for they will leak sometimes if they are old and have been messed with .
2/20/2011 7:30:20 PM •
Haier...
•
Answered
on Feb 20, 2011
As soon as the water
sounds like something is in the sump look in the bottom of the dishwasher under bottom rack and make sure there is nothing in it
1/28/2011 10:57:37 PM •
Haier...
•
Answered
on Jan 28, 2011
Hello, my Haier dishwasher stopped
Have the same problem with mine and have found no solution in the manual or web. four lights flashing and beebs ten times every ten seconds, water coming in and draining out constantly, very frustrating!
1/8/2011 12:39:01 PM •
Haier...
•
Answered
on Jan 08, 2011
I turn it on, press
Hello. Do this:
1) Shut off the dishwasher and wait few seconds.
2) Turn on the power again by pressing power button.
Press Start/Pause button. After few seconds drain pump will come on
for short period of time twice. You will hear some type drain pump
noise in the dishwasher. Observe if the drain hose is pumping water out
in to the sink.
3) Immediately turn off the dishwasher after the second drain.
4) If there is still water left in the dishwasher, repeat first three steps again
until the water is removed completely.
10/3/2010 10:25:26 PM •
Haier...
•
Answered
on Oct 03, 2010
My dishwasher goes through its
Hi there,
Well first of all you can check out the water-inlet valve -most cleaning problems are caused by the dishwasher not getting enough wash water, so the water-inlet valve is often the cause. This valve is usually at the bottom left or right of the dishwasher, behind the lower access panel. It's the device with the main water line from the house, a rubber tube to the dishwasher, and two wires attached to it. When a water-inlet valve is defective, you may hear the sound that's usually referred to as "water hammer." If the water-inlet valve is defective, you need to completely replace it. Further you can check the drain valve - Some dishwashers have a valve (or gate) that should open only during draining. If debris lodges in the valve, it can't close properly, so water drains out during the wash cycle. Most dishwashers drain into the garbage disposer. If yours does that, listen for water flowing into the disposer during the wash cycle. If you can hear it then, the drain valve may be clogged. Please post details about the model number of your dishwasher for further help or information.......
Good Luck!!
Thanks
6/28/2010 8:22:59 AM •
Haier...
•
Answered
on Jun 28, 2010
DW12-PFE2-U lights up but will
Hi there,
Well first of all you can check out the door switch - The door switch is important because, if it's defective, the dishwasher won't work at all. To reach it, you need to remove the control panel cover, or sometimes the interior liner of the door. If it's defective, you need to completely replace it. Your switch also may be locked in place by a locking clip. If this is the case there should be a button or a lever that you can press or pull, which will release the switch and it can simply be removed. Please post comments for further help or information........
Good Luck!!
Thanks
6/7/2010 10:32:56 AM •
Haier...
•
Answered
on Jun 07, 2010
Dishwasher cycle goes on and on like for an hour
if the sump is clogged up with with debris or the macerater is broken or the heater is not operating , the dishwasher will not operate properly and operate for a long time. Best off to call a reputable service company such as Sears.
2/6/2010 4:11:05 AM •
Haier...
•
Answered
on Feb 06, 2010
Not finding what you are looking for?