20 Most Recent KitchenAid Architect Series KEBC208KSS Electric Double Oven - Page 4 Questions & Answers

Element burnt out or control board is bad.

F2 E1 means that the keypad cable is unplugged.
Gain access to the control panel and keypad. Check keypad connector for firm connections. Keypad connects to the control board. Press CANCEL. If error code returns after 60 seconds, the keypad needs to be replaced. If your control board and keypad are incorporated as one unit, then the control board needs to be replaced.

Hello & Welcome to FixYa

F2-E0 error code indicates a open/shorted oven temperature sensor and to solve this problem the sensor needs replacement. If you wan to be sure before replacing the sensor then you can test it with a voltmeter for around 1100ohms....if it reads more then this then it needs replacement however, if the reading is around or less then 1100ohms then it is the control board that needs replacement. Please get back to me if you have any other questions.

Kevin

If you're searching for an obsolete keypad for a Kitchenaid Oven/Microwave unit, FixYourBoard.com has replacements by Ledgestone Technologies. These units are backed with a 2 year warranty. Save your $ and save your oven from the landfill. We have you covered! Call 512-355-1108 for more information and to order.

I would say your stove is old and the door closer springs are burnt out and shot. Yes if the door is open even a little bit the stove will not heat up. If the temp is not right the cakes will not bake right. Get a new one. or get a repair person to fix it. It will keep your wife happy.

Contact the landlord and have him repair or replace the oven.

Ledgestone Technologies has replacement keypads for NO LONGER AVAILABLE Whirlpool and Kitchenaid models. Each one comes with a new ribbon cable and 2 year warranty. Contact FixYourBoard.com for more information! 512-355-1108 [email protected]

If you are hearing a clicking sound, that would be the igniter trying to light the gas, however you said elements not heating up which says it's electric... hmmm. If it's electric, try the broiler and see if the element comes on. It's pretty easy to troubleshoot by process of elimination. By all means do not try and repair it yourself unless you are qualified working with electrical.

Only thing you can really do at this juncture is to disassemble unit and meticulously clean any and all keypad contacts and switches. If that does not restore operation then you have to face reality - need new electronics. The new stuff looks nicer but the old controls were much more reliable!!!!!!!!!

You are very lucky if that machine lasted as long as it has. if you replaced those hinges in 2007 that's 10 years. The last one i bought they said we will be lucky if we get five to ten years out of the new one. Unless you want to put money in this one its probably cheaper to buy a new one in the long run. They could not care less if you tell them you won't buy anything from them again. I had a large company official tell me that.

The oven vent must be pressurizing form outside wind pressure.

Parts #: W10317343 Substitution: WPW10317343 $145.98 at sears Parts #: W10354052 Substitution: WPW10354052 $125.92 at sears Part #: W10317347 front LED board $230 at sears Many ovens have a bi-metal thermal fuse-also called a thermal limit switch-that protects the oven from overheating. The oven thermal fuse trips when the temperature in the oven gets too hot. After the thermal fuse trips, the oven won't heat. If the thermal fuse trips after the self-cleaning cycle, try resetting the fuse by turning off electricity to the oven, removing the exterior back panel, and pushing the reset button. If the fuse tripped during normal operation, replace it. If the problem persists, the electronic oven control board might require replacement. Reset the thermal fuse after replacing the control board.