Questions & Answers for: kitchenaid refrigerator freezer door jammed

...Kitchenaid refrigerator and have had at least six service calls over the past two years due to the ice maker not functioning properly. Gears have been replaced, sensors replaced, the whole ice maker ...

ice jams in KUIS18NNJB Kitchenaid under counter ice maker Cube cutting grib has power but cannot cut ice slab into cubes before the next ice slab is produced; get ice jam. There are 2 sets of wires on

...refrigerator. By leaning the fridge back toward the wall about an inch helped keep the water and ice in the tray. Remember to remove items that block air flow in the freezer. Remove the ice bin and ...

...door not fully closing allowing warm, humid air to rise into the freezer. This will cause cubes to fuse together causing a large jam inside the dispenser. There is a kit available which contains all ...

freezer door to let it warm up. When I chill the freezer again do I keep the icemaker arm up until the freezer is cold and then lower it to make ice? Dont leave freezer door open it will cause alot of

...freezer is burning HOT to the touch; so hot that the rubber door closures are enlarging causing difficulty in closing the doors. Fixable or do I just need to buy a new one? KitchenAid Superba Model ...

...kitchenaid superba ksrs25ilwh side by side fridge. The freezer is working fine but the fridge wont get cold enough even at the lowest temp check the damper vent door for proper opening and closing as ...

Kitchenaid KSRS25 Ice dispenser blades get stuck Auger/blades getting jammed by single ice cube (inspected/ran ice dispenser with door open and few ice cubes present). Have emptied and defrosted ...

...kitchenaid refrigerator It is happening because the air getting into refrigerator through the small gap between the door so please Change the refrigerator's rubber seal thermostat set too low Without ...

...maker keep making ice? when ice bucket is full, so when you open the freezer door, ice falls on floor Even the Ice Maker switch is in the OFF position The level sensor is jammed or not fully ...