The printer turns on but afterwards it displays 1, P, 0, 7. then it repeat displaying P07. What does it mean? Please help me. Thank you. God bless.

Device is not functioning properly or to clear memory, reset it

• On the operator panel, press the button. (The display will go blank.) Note: It may be necessary to unplug the power cord if pressing the ON button does not shut off the printer.
• Wait approximately ten seconds and then press the button again.
• Wait until the device has completed its cycling process before submitting another job request. Note: It may be necessary to unplug the power cord and retry if the above steps do not clear the error.

If Still facing issues please call at 1(800)243-0051 ' 0800-046-5291 UK..

Is there any fault codes on the display. If yes,re post the make of the machine and the code number. God-Bless!

please download your owner manual, go to www.fitness.manualsonline.com or www. retrevo.com and see the symbol meaning.
God bless you

A old trick which may help:
Unplug the power cord from the printer. Wait about 1minute. As you plug in the power cord back in, press and hold the power on button for about 15-30 seconds, then release the button. Now power up the printer and see if the error clears.

God Bless.

1) PLEASE replace batteries by new ones.
2) clean the batteries contacts with special spray contacts cleaner
3) retight the spring contacts batteries with a pliers for better contacts very important!
4) adjust the reed switch see the diagram attached.
God bless yu

1) test the power supply for LED Displays.
2) Led Displays faulty, repair.

God bless you

1) under the display board, with the point from eraser pencil, small orifice, introduce the point, and click the small swithc, and turn On again. Previously Turn OFF.
God bless you

Solution 1: If the device is not functioning properly or to clear memory, reset it.

1. On the operator panel, press the button. (The display will go blank.)

Note: It may be necessary to unplug the power cord if pressing the ON button does not shut off the printer.

2. Wait approximately ten seconds and then press the button again.

3. Wait until the device has completed its cycling process before submitting another job request.

Note: It may be necessary to unplug the power cord and retry if the above steps do not clear the error.


Solution 2:
Step 1: Entering Service Mode

* While the printer is OFF, press and hold the Start/Stop button (Resume/Cancel in some other models).
* While holding the Start/Stop button, press and hold the POWER button.
* When the POWER LED (green light) lit, release the Start/Stop button (still holding the POWER button).
* Press the Start/Stop button TWICE (still holding the POWER button)
* Release the POWER button.
* Wait for the LCD to display "0′ (zero).

download new drivers and install them, its a driver problem

Hello I have a little problem my printer print well for scanning it is not tell me what I have to do and the copy too doesn't work properly.
thank you for your help. May God bless you in everything that you udertake in life. keep on