Wont drain My washer will not have a full spin/drain cycle

sounds like the transmission needs replaced

Might have strings or coin in the pump.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Most typical thing wrong when a washer agitate but wont drain/spin is a defective lid switch. Reply back w/brand and model number and ill tell you where yours is and how to check it.

Pump is blocked or shot

Pressure switch made telling the machine it is full of water hence no spin.

Drop hose into bucket to drain the water off and the machine should spin, you may be better dragging the washer to an outside door and let all of the water run away at once .

Make sure that the drain hose is unclipped from the back of the machine so that the bottom of the hose is as low as you can get it

POST ME THE MODEL NUMBER. AND ALWAYS POST MODEL NUMBERS WHEN NEEDING ASSISTANCE PLEASE:)))

There is an awesome guy on fixya with this:

http://www.fixya.com/support/r622155-kenmoreelitewhirlpoolduetdoorjammed

http://www.fixya.com/support/r615354-fherrorcodewhirlpoolduetkenmore

Sounds like your drain poump is failing. It's spinning lighter loads but not able to take a full load. I woule definately replace the drain pump,

Water is draining but machine is not reaching it's full spon.

Your symptoms that indicates a broken motor coupler. If your washer will drain and fill but has not agitation action or spinning action that would indicate a broken motor coupler. The motor coupler links the drive motor to the transmission.

find tech sheet at bottom of washer and follow instructions for checking motor controller (at bottom rear)