Belling Ovens - Page 11 - Recent Questions, Troubleshooting & Support

We solved this by pushing both the "start cooking" and "stop cooking" buttons at the same time (these are the ones showing a pan with steam coming out of it and a pan that says stop above it). While holding these down we used the plus and minus buttons to set the time. After doing this we were able to turn the oven on.

NEED NEW FAN OVEN ELEMENT THAT CAN BE FOUND HERE You need Element code AB20 on link belowhttp://cookerandovenelement.co.uk/bellingfanovenelement.htmlelement is located on back wall of oven you need to pull oven oven to remove the element element is held by two nuts from back and i screw from front

It all depends on whether the scew heads are flat, or have slots for a screwdriver.
If no slots , then you are going to have to access the heater from the rear of the outer rear cover of the oven.
If the screws can be undone from inside, then simply unscrew them, and pull the element out towards you.
Hope this helps.

Yes ,I would say that without doubt the element has gone
Elements can go without any warning at all.

If it has a timer, then make sure it is set to manual, and not auto, otherwise the oven will not come on.
What usually happens is, if you have a power cut, or switch the oven off, then the timer automatially goes to auto when the power is on again.

Please rate my solution.
Thankyou.

I have the same problem. I have inherited a Belling Synergie multifunction double oven. The Model No is worn out - yet there is a specification 492SS which isn't. I am going to purchase the element with this number and hope this works.

you need to set the time if after that it still don't heat then you will need a heater element OK no there not running off the same one OK

Might want to check the heating element

There is a post on fixya with a downloadable manual:

http://www.fixya.com/support/p34919-belling_xou252_electric_single_oven/manual-18022

Hope this helps!