I JUST PURCHASED AND INSTALLED A BRAND NEW [SEALED UNIT] AVX2 AND IT WONT TAKE A CD...IT ACTS LIKE IT DONT WANT IT INSTEAD OF PULLING IT IN...ANY IDEAS?

need proper tools to slide down the sides to release locking pins or remove dash to get to the screws

there is no power on the red wire of the unit when you turn the key to acc on your car. check all the fuses on your car

Hello, Jennifer.

Since you just purchased the emachine two days ago and already there is a problem, I would suggest that you either return the computer to where you purchased (most place have a 7-day return policy) or contact emachines. Here the link to emachine's Customer Care: http://www.emachines.com/support/warranty.html

I suspect that the CD drive is faulty and should be replaced.

Hope this helps.

sounds like your slugin oil back to compressor and its over working itself especially cause you have low amprage,you need to pull a vacum on the systemm and bring it down to -25 psi and hold that vac.charge for a good 2 or 3 hrs and then recharge with new freon not the freon that was pull out of system,dont flip jug or try to put any liquid in even know the system will act like it wants liquid just add the gas slowly and it will eventually recoop it charge and amprage should rise to 8.9 to 9.2 depending on the outside temp.note: if this unit is under warranty by manufacture they should replace it due to the fact of a brand new unit that has never ran properly since installed call manufacture for complete waranty details heres the basic warranty this unit comes with and phone # - WARRANTY
Labor Warranty Limited 1-year entire appliance
Limited 5-year sealed refrigerating system Parts Warranty Limited 1-year entire appliance
Limited 5-year sealed refrigerating system Have more questions? Please contact 1-800-626-2005.
hope this helps

Download the VISTA software /driver and install it instead.

http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=238&modelid=10444#DownloadDetailAct

Here is a link to Dell's website., You can download the drivers here. Just follow the few prompts to specify your operating system and you should be ready to go. http://support.dell.com/support/downloads/driverslist.aspx?c=us&l=en&s=gen&ServiceTag=&SystemID=PRN_ALL_A924&os=WW1&osl=en&catid=&impid=

I have the same Kenwood unit and mine worked great for over 2 years.... I now get the same 05 error code whenever i insert any cds.... I havent yet been able to find anything about this on the net... I am about to take the cd player in for the extended warranty I purchased with it.... It is by far the best cd player that I have ever owned...............

hi. if you have standard slot for head unit this stereo will fit with any problems.jvc just look like a biger but is not.the frames all smool.sorry my language is poor!have a nice sound

your set could have damage after powering it up and connecting speakers.have the tech repair it.good luck.

I am having the same problem but only with a KDC-MP335 unit. I installed it in a 1995 Jeep Grand Cherokee to the stock system, pretty easy install just matching colors for wires and everything works (Radio). but not one CD plays. it says reading and it acts as if it is playing the tracks but no sound... what is going on? did I mess up wiring it or something?