HP photosmart C7280 will not print. it is correctly plugged in and the computer screen is saying ready to rpint, but it will not print at all

remove and insert the cable in another usb port.if the problem continues change the usb cable and try

In the printer properties make sure port is set to TCP\IP and make sure printerIP is correct.,

1. Unplug power cable while the printer is ON.
2. Press and hold the '#' and '3' buttons, and plug the cable back into the printer.
3. Continue holding the buttons down for 20 seconds, and then release it.

if doesn't initialize successfully repeat
on step 2 press and hold the '#' and '6' button and plug in the power cable.

have you use duplex unit?
you have to change your driver option both side print

Thanks

Try this...hope it helps! ">

Hello,

Check our web site at: www.ccl-la.com/hp.htm We have a step by step guide to correct this problem. This error is caused by air in the ink feed tubes and the guide will help you do a purge on the lines.

I hope this helps, If so please rate my solution.

Buddy
Corporate Computer
www.ccl-la.com

Does the c7280 use seperate Magenta and PhotoMagenta cartridges? If so make certain the right cartridge is in the correct slot.

Should be in the HP print centre software on your computer

plz try by reinstalling the drivers

dirver conflict, completely remove from OS, take off network and see if HP works independently well. reset on network and share again.