1500 series all in one.check cartrage or paper light is blinking

Fiend your solution direct from EPSON. Here is your solution...

http://www.epson.com/printer/prob676ijt65/solution

tiuy24

printer ane error prin color'nya g bisa

There is a great possibility that that the cartridge is bad.
You could take it back to Ink Stop to check and for an exchange.
Most of the time the cartridge may be overfilled.
Check the cartridge printhead, if it is wet, blot it dry with a paper towel.
If is a color cartridge, check for all 3 colors are present
by pressing the printhead on a piece of paper
if 1 color is missing, the printer will sense the cartridge as bad.
Do the following steps in installing the cartridges
Remove both catridges
Unplug printer, wait 3 minutes, plug back printer.
Turn printer back on
Wait until printer stop
Check the contacts of the cartridge to be clean
Install both cartridges.

When you put in a "new" cartrage the printer sens an electrical charge to the cartrage to set it up properly. So I would treat this as a new cartrage, rather than a refilled one. Go to the printer menu and re install the ink cartrage in question, it should recognise it and start the function as a new one, good luck

must have both cartrages in to work. insert another one turn off and restart his should solvre problem

Hi

Try running a head cleaning cycle from the maintenance menu, then print a nozzle check. try to run 3 head cleaning cycles then try printing again
. If all fails call epson for replacement.


Hope this helps

The printer does not feed paper from the tray and then states that there is a paper jam. I have removed all paper and there isn't a paper jam. It will feed paper through the lower roller and straight into the printed paper tray, but will not feed a new sheet.

Hi
You must define in printer Properties that you install a new cartridge!!! Just go on Printers and faxes, right click on printer, select properties, advance and click install new cartridge!!!
good luck!!!

check cartrages plz your cartrages ok after you clean pickup roller i hope your pro. solve

i had the same problem but i finally figured it out

1. open the cover

2. pull the ink cartrage thing to the right while you push the center paper feed button

3. it should move now