Water wont empty after wash alarm keeps buzzing and red light shows a picture of a tap

Your Pump potentially faulty I think. replace it. go for cheapest option first.

check that the water flow solenoid is operational and not blocking of the spray rinse requriement

Some appliances malfunction can be displayed in hexadecimal or in binary code.
So your device is defective and shows you what's wrong. You have to count how many times flashes red light and how many times flashes green light. Red light shows the first error number and green light the second error number.
For example: you forgot to close the door and you started washing machine. After some time (timeout) will generate an alarm. Four times will flash red light and once the green light which means error code " E41 " or "Open door"
" E20 " means "No drain water"
" E10 " means "No fill up water"

Dado

Do you hear any noise when it tries to fill with water?You do have the taps turned on correct? :)

When I had a problem with my simpson washer, with all 3 water temp lights blinking, it was a blockage in the pump, I emptied the washer and disconnected the host to the pump underneath, then cleared out the pump and put the hose back on, problem solved.

stops between wash

has someone interfered with the inlet tap. The buzzing is normally a sign that the appliance is trying to take water but tap is off.

This usually indicates a problem with the water supply to the washer.
Check the tap/s are fully turned on, check that there is no restrictio orr kinks in the hose/s.
Make sure you have good water pressure.

check your battery because if its deade your car may show diffrent alarms

colman uses the furnace to power the attic vent fan . Cheaper that way I guess. It just supplies your attic fan with power so it will vent thus keeping your home a little cooler in the summer.
not a big deal. you can shut the alarm with a switch ot cut power to the alarm.