MY PRINTER DOESN'T CONTINUE PRINTING IT PRINTS ONLY QUARTER OF THE PAPER AND IT GIVES SOUNDS WITH THE PAPER STILL INSIDEE AND WHEN I TAKE IT OUT IT IS FULL OF INK AND BLACK WIDE LINES.

Your Printhead is Faulty. Needs Replacement

Hi

Basics first (which you may have already considered).

Explore the Canon Printer software settings.

You need to adjust the Printing Preferences when switching from paper printing to photo paper printing.

Also look at the Print quality and colour saturation settings and try to print in Fine or High Quality when printing on photo paper

If none of the solve the problem, check if something is not stuck in the paper input tray and pressing the photo paper to close agasinst the scanner.

Make sure the paper is properly centered and cradled with the addjusble paper guide on the In Tray.

If tall new none of this works, install new cartridges and conduct Nozzle Check and Print Head Cleaning maintenance and then test print again.

I hope this helps.

go to printers and faxes right click an d select printing preferences on 4350d and select paper as A4 . Press apply & ok. Now try printing on A4

It has dust or built-up goo on the feed switch. Try some canned air

Does this happen when printing from the cassette (bottom tray), or the sheet feeder in the back, or both? Check that the paper guides are set snugly (touching but not buckling the paper) against the edges of the paper.

I suggest that you go into the printer properties section on control panel. There Will be a section which allows you to tell the printer the type of paper, size desired, orientation of photo to horizon and etc. There is also likely a selectable setup procedure on the printer's own display to do the same... It sounds like a basic setup format issue....

loose the static ,disconnect from pc and restart both of them together so sync is possible

Are you saying that the printer prints in B&W but not in color, or only that it will print a test page with B&W? It might be that the color ink cartridge is dry.

Replace the exit sensor clipped into the moulding above the fuser. (Very Common)

Sounds like the paper is the issue.
If is prints fine on normal print paper and not on the letter head, There is a texture problem with the ink sticking to that specific paper.