Type 11D motor for lionel 627 diesel switcher

Here is the manual for the switcher. http://www.lionel.com/media/servicedocuments/71-8474-250.pdf
Here is a link for gatemen, select the one you have to find the manual.
http://www.lionel.com/Products/Finder/SearchResults.cfm?doAction=search&Keywords=gateman&CategoryID=39&Gauge=&RailLineID=&CatalogID=&CollectionID=&searchWithin=Current
Here is the link for power supplies.
http://www.lionel.com/Products/Finder/SearchResults.cfm?doAction=Browse&CategoryID=40.

From the Lionel User Guide for this engine.

it forward to release the two rear clips from the frame slots.

2. To remove the lamp, gently push the lamp down and turn counter clockwise to disengage

the lamp from the socket. Refer to Figure 6.

3. Replace the expired lamp with Lionel part no. 600-0363-300, available from your local

Lionel Authorized Service Center or Lionel Service. (For more information, see Lionel

Service on page 12.)

4. To reinstall the shell, first insert the rear tabs on the body into the slots on the frame. Line

up the screw holes on the frame and body shell, and reinsert the screw. Make sure all of the wires are inside the body before you tighten the screw.
This is a 14V bulb


This

Have you checked to see if the direction switch is on? Most Lionel locomotives can be set to run in one direction by turning the direction sequencing off. This is true for the newer electronic direction circuits and the older electromechanical E-units. Sometimes the direction units fail and the locomotive will only go in one direction or sits in neutral. If that is the case, the direction unit will need to be serviced (mechanical type) or replaced (electronic type). Go to Lionel.com for additional information and help.

Here's a link to Lionel's track documents.
http://www.lionel.com/CustomerService/service-documents/index.cfm?type=supplement&categoryIDList=83&doAction=search&product=&productNumber=

If you are asking about the 2-4-2 scout type, a few drops down the stack.
If you are asking about the diesel switcher, it has no smoke unit.

Here is a link to contact Lionel Parts & Services:http://www.lionel.com/ContactUs/


They'll be able to supply you with a motor.

Please go to the Lionel WebSite and type:

73-1960-250 in to search. This is a PDF file for the Polar Express which was released by Lionel in 5/05. You can also go directly to: http://www.lionel.com/media/servicedocuments/73-1960-250.pdf

Many of the MTH Protosounds 1 and 2 and Trainmaster will not work with the Lionel CW-80 electronic power source. The output waveform is so non-like sinusoidal. The electronic sound systems will not usually respond to this waveform and when they do, the sound will be garbled. Use another power source.

This is just a guess but it may have powered headlights or other lights on the train at one time, some of then even had a smoke producing device on them.

The horn has a screw in it to adjust the pitch. Try adjusting it to see if you get sound.