Frymaster Dean H22 Deep Fryer - Answered Questions & Fixed issues

Temp got to hot and shut down high limit. Also check for a broken wire to high limit

There should be some kind of spark sensor usually where the gas line plugs into the pot. There is one wire hooked to it take the sensor out and clean it good. Soot could be building up on it causing it to nolonger sense a flame.

I would contact Frymaster at 1-800-551-8633. Ask for tech support.

Hi, As per our session, No. The sounders are probably bad or may have been hooked up backwards upon reassembly. GCS in KC would be the ones to contact for parts. Thanks for your business. If I can be of any more assistance, let me know. kstfas

Defective thermostat.

Defective thermocouple. It is the metal tube that is in the flame of the pilot light.

One time this happened to me on a gas stove. I used an electric drill with drill bit to clean it out. It will only work if the line is straight, no bends in the line.

Here's a link that may help,find your model and click on it,k. http://www.frymaster.com/minisite/service/manuals

always

This might be due to a loose wire in the light that or it is going out.

Drill out all the small holes on the burners(pillars). Remove them by taking out the two bolts at the top of each burner.

The burner or the burner venturi is clogged. The burners are held in place with 2 bolts at the top and you need a 1/2 inch wrench. Remove the bolts and lift the burners off the brass orifices. Make sure all the holes are clear. If they are clogged they need to be drilled out. You should not have yellow in the flames in the burner tube.... kinda looks like the are sooting. This causes flames to come out the bottom of the burners.

There is an adjustment screw on the main gas valve, usually under a cover screw. It will be near where the small pipe that goes to the pilot light.

venting is bad ---- soot build up - obstructions---------clean your unit

Hi there. Hi limit may be tripping off due to high oil temperature (power supplying the gas valve is connected in series with the hi limit). Verify if the thermostat is not shorted, also please check the thermostat calibration if it is good. Regards.

First look down the stack, with the fryer off, and see if there is something that fell down in there. If that is not the case then check to ensure that all of the burners are on when you turn the fryer on. If those check out OK then you probably have soot buildup in the burner tube. Remove the burners and clean out the tubes.

I need to replace it

Likely one of two things. The thermostat is stuck on or your gas valve is bad. Identify one of the wires going to the thermostat and disconnect it, if the burners shut off with the thermostat disconnected the problem is the thermostat, otherwise it will be the gas valve. All this assumes the unit is wired correctly and has not been changed. If your burners are not shutting off due to a bad gas valve or thermostat you are at risk to have a fire! Be sure to get this fixed immediately and it is unsafe to operate the fryer until repaired.

Hi there.Filter paper may be clogged causing the pump motor to trip-off after the filtration of the second fryer, better scrape off any filtered debris on paper afrte filtering.Also oil temperature must be at least 250F or above to lessen the load on pump motor as oil with low temperature is thicker than oil with high temperature.Regards.

Hi there!Check the hi-limit by removing the wire at terminals and connecting an ohm-meter across, it should have continiuty, if it does not have, better replace it with a new one.Regards.