Frigidaire FAM157S1A Air Conditioner - Answered Questions & Fixed issues

0helpful
1answer

As soon as I plug into wall compressor switches on without unit being turned on. Turn unit off and compressor never shuts off until whole unit is unplugged

Sounds like the contacts in a switch or relay are stuck together giving power all the time. Get someone with electrical training to check the power side of things.
7/4/2015 6:08:21 AM • Frigidaire... • Answered on Jul 04, 2015 • 564 views
0helpful
1answer

I need a manual

here is the link: Frigidaire Manual Search Results Please mark my answer helpful.
1/6/2015 4:30:10 AM • Frigidaire... • Answered on Jan 06, 2015 • 148 views
0helpful
1answer

Thermostat will not cycle compressor temperature

Good Afternoon Friend, I understand that the thermostat is not cycling the compressor on and off on your Frigidaire air conditioner, model# FAM157S1A. Please check the temperature sensing element to see if it is touching a cold coil. This will be located behind the air filter. Straighten away from the coil if it is touching. The other possibility is the compressor shut-off by changing modes. Wait approximately 3 minutes and listen for compressor to restart when set in the COOL mode. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful. -Best Regards- WP
7/3/2014 10:14:41 PM • Frigidaire... • Answered on Jul 03, 2014 • 133 views
0helpful
2answers

Not staying cool

sounds like it is either low on Freon or the compressor is going out. The blowing ice cold is an indicator that it may be freezing up because the low Freon. when it stops blowing cold, turn it to fan only mode and see if it gets colder again. If that is the case then the unit is low on freon and freezing up. I know that sounds confusing but that is how AC works. The low freon pressure means the gas is expanding too fast and the air flow cannot take up the cold from the evaporator fast enough. Turning the compressor off and keeping the fan on will alow the room air to take up the cold.
5/7/2016 4:25:35 AM • Frigidaire... • Answered on May 07, 2016 • 394 views
0helpful
1answer

FAC107P1A

DRILLED INTO COOLANT LINE WILL NEED TO FIX AND RECHARGE
4/22/2014 5:21:00 AM • Frigidaire... • Answered on Apr 22, 2014 • 78 views
0helpful
1answer

Why doesn't it have any condensation

Hello, if the unit has a drain it may be blocked and not allowing the water to drain. If no drain is present then the unit uses the condenser fan blade to scoop up the condensate and splash the condenser. This is done for two reasons, to keep the condenser cool and to evaporate the condensate
7/6/2012 9:26:58 PM • Frigidaire... • Answered on Jul 06, 2012 • 497 views
0helpful
1answer

The temperature gauge has stuck

Turn the unit OFF using the ON/OFF Switch and unplug it for 15 minutes. After the time has elapsed, plug the unit back in and turn the unit ON. With any luck, the electronics reset and reverted back to the original factory settings. You should know immediately, once the unit is turned ON. If they did, you can now set the controls as you like. If they didn't, the control panel will need to be replaced. Parts are available from Frigidaire or their authorized distributor.

Hope this helps and thanks for choosing FixYa.
8/7/2011 10:10:51 PM • Frigidaire... • Answered on Aug 07, 2011 • 1,629 views
0helpful
2answers

Accidentally cut the power chord.

get some tape and splice it back to gether. wire nuts would be best .. just make certain your connections are tight and well taped.
7/14/2011 8:45:16 PM • Frigidaire... • Answered on Jul 14, 2011 • 178 views
0helpful
2answers

Why won't my Frigidaire window unit come on?

Check power at outlet.
3/17/2024 4:21:17 AM • Frigidaire... • Answered on Mar 17, 2024 • 261 views
0helpful
1answer

My Frigidaire ac wall unit model FRA144HT2 has a humming sound after powering off and randomly starts humming hours after pushing the reset button

A humming sound coming from your Frigidaire AC wall unit after it has been powered off could be due to a few different reasons. I can provide some potential explanations and troubleshooting steps to consider:
  • FAN MOTOR
  • THERMOSTATE DELAY
  • ELECTRICAL ISSUE
  • REFRIGERANT FLOW
  • OTHER MECHANICAL ISSUES
9/8/2023 9:20:34 AM • Frigidaire... • Answered on Sep 08, 2023 • 44 views
0helpful
1answer

How do I change temperature from Celsius to Fahrenheit on Frigidaire Gallery Refrigerator, model EPTWFU01?

EPTWFU01 is the water filter part number. It isn't the model number of the refrigerator. Please check the model number. Often the model number is on the back of the refrigerator. Not all models support changing the temperature units. If your refrigerator has a button labeled C/F. Try pressing that to toggle back to Fahrenheit. On another model, FG4H2272UF, press and hold the + and - keypads on the refrigerator side of the control panel for 5+ seconds. One Frigidaire Gallery refrigerator is the GLHS36EJSB. The support page is https://support.frigidaire.com/Owner-Center/Product-Support/GLHS36EJSB . The current link to the manual for this model is https://na2.electroluxmedia.com/Original/Electrolux/Electrolux%20Assets/Document/Complete%20Owners%20Guide/English/241856000en.pdf . This model doesn't allow the units to be changed. The documentation for FG4H2272UF is available here: https://support.frigidaire.com/Owner-Center/Product-Support/FG4H2272UF . See the page 15 of the manual, https://na2.electroluxmedia.com/Original/Electrolux/Electrolux%20Assets/Document/Complete%20Owners%20Guide/English/A10883135en.pdf , for the information above. I hope this helps. Please add a comment with your refrigerator's actual model number for specific directions for toggling between degrees C and degrees F. Cindy Wells
9/3/2023 2:23:38 AM • Frigidaire... • Answered on Sep 03, 2023 • 56 views
0helpful
1answer

Window ac/heater freezes up when using the heater?

This is likely due to a lack of airflow. Make sure that the air filter is clean and that there are no obstructions blocking the air intake or exhaust vents. If this does not resolve the issue, you may need to have a technician come out and inspect the unit for any other potential issues.
2/14/2023 12:17:18 AM • Frigidaire... • Answered on Feb 14, 2023 • 72 views
0helpful
1answer

Frigidaire model fftr1835vs styrofoam inside filter housing unit. Should it be there?

Not 100%certain to what styrofoam you are referring to but there is definitely styrofoam components inside the machine. The entire drain pan is made of styrofoam, I would not touch it.
7/4/2022 9:22:49 PM • Frigidaire... • Answered on Jul 04, 2022 • 268 views
0helpful
1answer

New Frigidaire Portable ac unit turning off and flashing 8.8

Have you drained the water?
7/2/2022 7:30:52 PM • Frigidaire... • Answered on Jul 02, 2022 • 83 views
0helpful
2answers

The "filter reset" button keeps turning on on my

The blower wheel probably is dirty. The unit is sensing that not enough air is flowing across the AC coil.
6/27/2022 12:31:44 AM • Frigidaire... • Answered on Jun 27, 2022 • 859 views
0helpful
2answers

The compressor on my Fas257r2a 25000 btu stops running before the room is cool. but takes awhile before compressor starts up again What could be the problem?

Mine is doing the same but it's very moldy and dirty. It worked well when we used it for the first month when we moved into our Gma's house. She left the unit. It's old yes but it worked fine before. Why is this happening? I'm going to clean it, but I have NO IDEA HOW TO GET IT OUT OF ITS CASE! HELP
6/20/2022 12:59:27 PM • Frigidaire... • Answered on Jun 20, 2022 • 142 views
0helpful
1answer

My Frigidaire 12,000 BTU window air conditioner is tripping as soon as I plug it in!

did you clean it with water? They don't mix. Use a hairdryer to dry thoroughly.
6/18/2022 6:59:05 PM • Frigidaire... • Answered on Jun 18, 2022 • 131 views
0helpful
2answers
0helpful
1answer

I have a Frigidaire FGH2272UF and want to change from centigrade to fahrenheit? Help

Here are some videos, but it looks by doing a search on that model, that you can't change it. Having said that, the manual shows both, but perhaps that is for display. https://www.manualslib.com/manual/1581184/Frigidaire-Fg4h2272uf.html?page=13#manual Videos https://www.google.com/search?q=Frigidaire+FGH2272UF+change+from+centigrade+to+fahrenheit This search forces your model to be featured https://www.google.com/search?q=Frigidaire+%22FGH2272UF%22+change+from+centigrade+to+fahrenheit It doesn't appear to be in the manual. Centigrade is much easier. Fridge at 3'C and Freezer at minus 18'C. Freezing is 0' and boiling is 100'. You can hang an American thermometer inside. https://www.manualslib.com/manual/1581184/Frigidaire-Fg4h2272uf.html .. ..
4/13/2022 6:15:05 PM • Frigidaire... • Answered on Apr 13, 2022 • 183 views
0helpful
2answers

Why is My Frigidaire wall unit blowing cold air on the heat cycle and why does my heat fan not go too high it at least stays on low

Is this an electric unit or does it run on fuel?
2/20/2022 6:31:15 AM • Frigidaire... • Answered on Feb 20, 2022 • 371 views
Not finding what you are looking for?
Frigidaire FAM157S1A Air Conditioner Logo

20 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Heating & Cooling Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Brad Brown

Level 3 Expert

19187 Answers

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Are you a Frigidaire Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...