SOURCE: 1999 jeep wrangler very little heat
YOUR RADIATOR HAS TRAPPED AIR IN IT AND NEEDS T BE "BURPED".
SOURCE: The heat in my 2006 grand prix will not get hot.
Are the 2 tubes that go to the heater core getting hot? If so, then the blend door is not opening to allow heat to get to the cabin.
Possible vacuum motor problem, either disconnected, or the controller for the blend door is broken is likely problem.
Troubleshooting by Symptom
Poor Heater System Performance
CAUTION
Check all fluid levels and adjust as needed, before operating vehicle for extended periods at idle.
Air Door Actuators/Motors
Removal & Installation
Recirculation Actuator
To Remove:
To Install:
Mode Actuator
To Remove:
To Install:
Air Temperature Actuator
Right Side
To Remove:
To Install:
Left Side
To Remove:
To Install:
SOURCE: need to flush cooling system of a 2005 chevy
You can buy a flush kit from your local auto supply store to add to your cooling system for this and future flushing. As for changing your thermostat - simply remove the thermostat housing - remove the old thermostat - replace with new (be sure it is the one rated for the season at hand) - replace gaskets (or use RTV gasket maker) and reinstall housing. Fill the system with proper % ratio of coolant to water (usually 50/50). Drive away happy.:) PS You can find your thermostat housing by following the top rad hose from the rad back to it at the intake manifold.
SOURCE: my temp gauge goes to
CHECK COOLANT FAN FUSES AND RELAYS. CHECK COOLANT LEVEL.MAKE SURE ITS NOT TOO LOW BECAUSE IF COOLANT TOO LOW . BY NO COOLANT AROUND OR COOLANT SENSOR NOT SUBMERGED IN COOLANT COOLING FANS WONT TURN ON.MAKE SURE YOU HAVE 50/50 ANTIFREEZE AND WATER. CHECK FOR CLAPSE RADIATOR HOSES.CHECK RADIATOR HOSE AT WATER PUMP.IF HOSE LOOK CLAPSE REPLACE IT AND BLEED COOLANT SYSTEM.IF EVERY THING HAS BEEN DONE YOU NEED ENGINE BLOCK FLUSHED OUT.HEATER CORE ALSO COULD BE STOPPED UP.A VERY HIGH MILEAGE ENGINE WILL OVER HEAT.OLD ENGINE LOSES COMPRESSION AND HORSE POWER.PUTTING MORE LOAD ON THE OLD ENGINE WILL MAKE IT OVER HEAT.IF COOLANT LEVEL IS LOW.BLEED COOLANT SYSTEM.START THE ENGINE LET IT IDLE FEW MINUTES WATCH THE COOLANT TEMPERATURE GAUGE.WHEN TEMPERATURE START RISING.TURN OFF THE ENGINE LET IT SET FOR 20 MINUTES.TAKE A LARGE RAG PLACE OVER RADIATOR CAP ON COOLANT EXPANSION TANK SLOWLY OPEN RADIATOR CAP JUST A LITTLE TO RELEASE A LITTLE PRESSURE AT A TIME.DONT OPEN CAP RAPIDLY OR YOU WILL GET SCALDED.ONCE THE RADIATOR CAP REMOVED.IF COOLANT LOW ADD MORE COOLANT IN THE THE COOLANT EXPANSION UNTIL YOU GET TO THE COLD MARK.REPEAT THIS PROCEDURE START ENGINE LET IT RUN UNTIL TEMP GAUGE START CLIMBING A BIT DONT LET CAR RUN TO OVER HEAT JUST IDLE UNTIL TEMP JUST START TO RISE.THEN YOU TURN OFF ENGINE. WAIT 20 MINUTES.THEN USE LARGE RAG OPEN RADIATOR CAP LITTLE AT A TIME. DO THIS PROCEDURE UNTIL THE COOLANT IN THE EXPANSION TANK STOP DROPPING. THEN ALL THE AIR IS BLEED OUT THE COOLANT.WHEN COOLANT LEVEL STOP DROPPING, WHEN YOU DRIVE CAR AROUND.AND TURN OFF ENGINE.WHEN ENGINE OFF CAR SET FOR A WHILE KEEP CHECK ON THE COOLANT LEVEL IN COOLANT EXPANSION TANK. THE COOLANT LEVEL SHOULD BE AT THE COLD MARK IN THE EXPANSION TANK.MAKE SURE COOLANT IS IN THE EXPANSION TANK.IF NOT AIR WILL DRAW IN COOLANT SYSTEM. CAUSING ENGINE TO OVER HEAT.IF BLEEDING AIR OUT THE COOLANT SYSTEM DONT HELP AND COOLANT FANS DONT TURN ON YOU HAVE PCM PROBLEMS.
Air
Temperature Control Blend Door Failure No Heat or no AC (dependes on
where door sticks)
In
all modern cars there is a tiny DC electric motor driven gear drive
that moves a plastic door that blends heated and cooled air from the
AC and the heater core, this is called (interestedly enough) the air
temperature control blend door actuator. The motor that moves this
door fails because the door starts sticking from warping, most common
complaint is no heat but it can be no AC as well. To replace these
parts (blend door and blend door actuator) you must remove the entire
dash from the car. Always have this problem confirmed by a dealer or
qualified repair shop as it is a very expensive repair.
Other causes of no heat in the cabin are engine thermostats that are stuck open (engine runs cold) or air bubbles in the cooling system.
1,581 views
Usually answered in minutes!
×