20 Most Recent 2011 Chevrolet Equinox Questions & Answers

The torque specification and the sequencing is as follows:
1. Brake caliper bracket bolt (front): 190 N.m. , 140 Lb-ft
2. Hub to axle shaft nut: 205 N.m., 157 Lb-ft
3. Hub to knuckle Bolts: 100 N.m., 74 lb-ft

2011 Chevrolet... | Answered on May 19, 2020

If it started after the pads and rotors were changed, check for bent backing plates rubbing on the rotor.

2011 Chevrolet... | Answered on Oct 27, 2019

the filter is located inside transmission requires to be disassembeled.you actually can drain and refill transmission.should be a drain plug at bottom area and a fill plug on side to refill.should be either 10mm allen or 3/8 drive plugs

2011 Chevrolet... | Answered on Oct 05, 2019

Just one blend door actuator that directs the Heat & A/C

2011 Chevrolet... | Answered on Jul 26, 2019

Door sensor for what ? Door ajar light lit on the instrument cluster ?

2011 Chevrolet... | Answered on May 21, 2019

My equinox suv TPMS cannot be reset why

2011 Chevrolet... | Answered on Apr 09, 2019

you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

2011 Chevrolet... | Answered on Apr 02, 2019

If you are talking about the rack-and-pinion, yes it is fairly complicated. Check YouTube. You will need a front end alignment afterwards.

2011 Chevrolet... | Answered on Mar 27, 2019

it's on the Primary Fuel Pump Module inside the tank.

On both the 2.4L and 3.0L (and most likely the 3.6L also), there are *two* pump modules inside the tank. The Primary is the one with more connections on it. It also contains the Fuel Level Sensor. This is why it has two electrical connections.

2011 Chevrolet... | Answered on Mar 13, 2019

There is no radiator cap, it's the expansion tank cap. Make sure you have fluid in the expansion tank. As long as there is fluid in the tank, your radiator will be full and you should get heat. No heat with a full radiator means there is another problem such as the heat solenoid that allows fluid to flow in the heater core may be faulty or your blend door that mixes the hot air with cooler air to control temperature may be faulty.

2011 Chevrolet... | Answered on Feb 24, 2019

So....is it running hot?....What does the temp guage say?....
This could be a number of different things..I wonder if the cooling fans are comming on?...I wonder if the radiator is flowing properly...Maybe the coolant temp switch is faulty...You prob need to take this to a qualified automotive repair shop to have some of these questions answered?

2011 Chevrolet... | Answered on Feb 20, 2019

Even the pay sites dont list a schematic for that vehicle. The affected parts are not related by system type. The only common point with them is the BCM and the clock spring. You may need to stop at a dealership and see if they will help you with a diagram etc.

2011 Chevrolet... | Answered on Jan 25, 2019

The exact location of the low-pressure port varies between different car models. But you can easily find it on any vehicle in just a couple of simple steps:
Start at the A/C compressor. It's attached to the front of the engine, and is powered by a belt and pulley. It can be either at the top or down along the side of the engine, as shown in this example:

One way to tell the compressor apart from other belt-driven parts, such as the alternator, is to turn the engine on but turn the A/C off; the compressor will then be the only pulley that's not turning. The the A/C compressor can also be identified because it has two metal tubes coming out of it.
The two tubes are different sizes. The smaller tube is the high-pressure line. The larger-diameter tube is the low-pressure line, which is the one you're looking for. It runs from the compressor back towards the passenger compartment. Follow that line until you find the one and only valve that sticks out of it, which looks like this:

It should be covered with a plastic cap, which you can unscrew to access the service port.

2011 Chevrolet... | Answered on Oct 23, 2018

The best way is to remove both the battery cables from your car battery and leave them off for 12 minutes. Then put the battery cables back on and tighten them up tight. Take your key and put it into the driver door. Lock and unlock the door 3 times. This should deactivate the anti theft system. If you need further assistance troubleshooting your vehicle, then seek out a technician, such as one from YourMechanic, that can assist you with the anti theft system. Auto Repair by Top Rated Mobile Mechanics YourMechanic

2011 Chevrolet... | Answered on Oct 23, 2018

check track for blockage

2011 Chevrolet... | Answered on Jul 12, 2018

Not finding what you are looking for?
2011 Chevrolet Equinox Logo

268 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Equinox Chevrolet

  • Equinox Chevrolet

Most Popular Question

many actuators in 2011 equinox

  • Cars & Trucks