20 Most Recent 2010 Chevrolet Equinox Questions & Answers

0helpful
2answers

2010 Equinox driver side rear wheel "locked"?

Yes get som leather or mechanic gloves on and inspect the brake area and fluid system. Ull need jackstands to keepcar raised. Jack is not safe. Get a repairmanual at apartstore for thatmodel
10/29/2021 11:25:33 PM • 2010 Chevrolet... • Answered on Oct 29, 2021
0helpful
1answer

2010 chevy Equinox LT Left rear wheel is locked. Could the parking brake be stuck on?

It could be a parking brake issue but it could also be a failed wheel bearing. If you get that wheel off the ground, does it flop around? If so, you need at least a bearing. It may have damaged the knuckle as well. It should have made a distinct roaring or humming sound as it was failing.
10/29/2021 10:13:24 PM • 2010 Chevrolet... • Answered on Oct 29, 2021
0helpful
2answers

I have a 2010 Equinox that only blows air out of the defrost vents. Does anyone know what could be wrong?

Isn't air supposed to blow out of the defrost vents ? Otherwise, how is it supposed to defrost a window if it isn't turned on defrost. Does it blow air out when not on defrost ?
8/17/2021 9:35:59 AM • 2010 Chevrolet... • Answered on Aug 17, 2021
0helpful
1answer

Jeep patriot low tire pressure warning reset how???

Put the car in "on" position, but don't turn the key entirely. Try to look for a TPMS switch under the steering, once found, press and hold it until the TPMS light blinks thrice. Now, switch on the vehicle and wait for about 20 minutes - the sensor will restart, and the light should go away.
3/30/2020 9:33:02 PM • 2010 Chevrolet... • Answered on Mar 30, 2020
0helpful
1answer

Child safety lock will not unlock on passenger side of 2010 chevy equinox

Need to try some wd40 spray it in the hole where the lock piece is and try to move it may take a little bit of time if not you will need to replace the lock assembly
3/31/2019 3:29:51 AM • 2010 Chevrolet... • Answered on Mar 31, 2019
0helpful
2answers

How to reset tire pressure monitor for 2010 chevy equinox

There are two different ways to relearn your Tire Pressure Monitoring System (TPMS). One is with a TPMS scan tool (this is the preferred method) and the other is the manual method (pain in the "you-know what", but requires no special tools or equipment).To use the manual method, set the parking brake. Enter into TPMS RELEARN using the Driver Information Center (DIC) controls. (SEE Owner's Manual)When you have successfully entered TPMS RELEARN, the horn will chirp and the left front turn signal will illuminate. Increase or decrease the tire inflation pressure on the left front tire for 8 to 10 seconds. The horn will "chirp", indicating that the left front tire pressure sensor has been relearned and the turn signal at the right front will illuminate. Repeat the process for the right front tire. The horn will chirp and the right rear turn signal will illuminate indicating that the right front tire has been relearned and now you must now repeat the process at the right rear tire. Then you will have to repeat this a fourth time at the left rear. When the left rear tire has been relearned, the horn will sound a "double chirp" indicating that the relearn process has successfully completed.At this time, turn the ignition switch to the OFF position and adjust all of the tire pressures to the specification printed on the tire certification label inside the drivers door/door pillar area.
12/2/2018 7:02:27 PM • 2010 Chevrolet... • Answered on Dec 02, 2018
0helpful
1answer

My backup camera on 2010 chevrolet equinox is not

Yes there's a release button on the key fob.
9/23/2018 11:00:52 PM • 2010 Chevrolet... • Answered on Sep 23, 2018
0helpful
1answer

Trac stabilizer light on, check engine light on, engine power reduced

It's all tied together in the computer system . When you start to loose control the computer takes over reducing engine power , applying brakes etc... to bring vehicle back into control . The throttle body on your vehicle is computer controlled . electronic throttle control . the gas pedal has sensors , the throttle body has sensors an a electric motor . The lights came on because the computer disabled these systems .
2/16/2018 3:03:48 PM • 2010 Chevrolet... • Answered on Feb 16, 2018
0helpful
1answer

Camshift censor on 2010 equlnox if not repaiar wants happens

If you have a faulty camshaft sensor, your engine won't run.
2/14/2017 12:42:26 AM • 2010 Chevrolet... • Answered on Feb 14, 2017
0helpful
1answer

Where is the battery located on equinox 2010?

Have to remove black cover front lower right hand side under that cover
2/14/2017 12:28:25 AM • 2010 Chevrolet... • Answered on Feb 14, 2017
0helpful
2answers

2010 6cyl awd Equinox emission control light came on suddenly and stays on what does this mean and can I drive it

The emissions are either running rich or lean or the NOX is high. The emissions have to be ckd & the computer scanned for problems. You can drive it but get it ckd out as soon as u can.It can be as simple as a vacuum leak
2/10/2017 11:34:30 PM • 2010 Chevrolet... • Answered on Feb 10, 2017
0helpful
1answer

Fuel filter change 2010 Chevrolet Equinox

This make, year and model has no inline fuel filter, the only fuel filtering is done at the inlet to the electric fuel pump inside the fuel tank, it never needs to be serviced unless the fuel pump is replaced.
12/30/2016 6:28:11 PM • 2010 Chevrolet... • Answered on Dec 30, 2016
0helpful
2answers

2010 Chevy Equinox,Check engine light P0017, Service Stabilitrak comes on and the car loses power. Tried checking the EGR to ensure not stuck open and have had no improvement.

DTC P0017: Crankshaft Position (CKP) - Exhaust Camshaft Position (CMP) Correlation Bank 1 Which engine does yours have 3.4 or 2.8 , 3.0 , 3.2 , or 3.6 L Chevy Colorado P0017 Case Study Part 1
12/16/2016 12:22:53 AM • 2010 Chevrolet... • Answered on Dec 16, 2016
0helpful
1answer

2010 chevy equinox accelerating problemscause

You will need to have the fault codes read from the engine control computer and then post them on this site.
11/10/2016 10:34:53 PM • 2010 Chevrolet... • Answered on Nov 10, 2016
0helpful
1answer

Why does my 2010 Chevrolet Equinox LT knock when starting?

Diesels do knock on start, but that is not the only knock that there is, I would need to hear the noise it may be a rod bearing
9/30/2016 8:13:53 PM • 2010 Chevrolet... • Answered on Sep 30, 2016
0helpful
1answer

Location park neutral solenoid on 2010 equinox

Solenoid, do you mean the park lock solenoid?
9/21/2016 9:30:28 PM • 2010 Chevrolet... • Answered on Sep 21, 2016
0helpful
1answer

Locating camshaft scensor 2010 equinox 2/4 ltr l/s

What is a 2/4?
9/21/2016 12:00:04 AM • 2010 Chevrolet... • Answered on Sep 21, 2016
Not finding what you are looking for?
2010 Chevrolet Equinox Logo

201 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6963 Answers

john h

Level 3 Expert

25714 Answers

Ryan Lutton
Ryan Lutton

Level 3 Expert

1267 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Equinox Chevrolet

  • Equinox Chevrolet

Most Popular Question

2010 equinox only blows air out defrost

  • Cars & Trucks
Loading...