[email protected] i want the default user and password for the router smc adsl barricade smc7401BRA

Hello, the default username AND password for most routers is 'admin' all in (lowercase) and without
the ' '
regards,
Nicam49

Can you clarify the problem?

Consdier first that both devices are NAT firewalls and your ISP probably only allows one address. So you would need to put one behind the other. This may not work like you plan. PCs behind the second will not be seen on the LAN by PCs on the first.

The N1 is a very good router. Consider relocting it to a more central location.

Another trick is to locate it near a central wall if it is block. By adding 1 remote antenna and drilling through that wall witha short antenna cable you can get much better coverage on the other side.

It could also be an ethernet problm 1. Power down SMC, plug WAN of SMC to LAN of router and power up SMC. If both devices show link lights and activity the hardware is OK. If not you need a "crossover" cable.

Hope that helps.

Go to the SMC site and download the appropriate manual.

For Windows XP, it says:
"To access the Router’s management
interface, enter the Router IP address
in your web browser http://
192.168.2.1. Then click LOGIN.
(By default, the password is
smcadmin. The default is case
sensitive.)"

Once you are logged in, you may change your password under the System -> Password Settings section.

Please Approve of this answer if I answered your question.

It should have reconnected automatically, but in any case that it hasn't reconnected just restart your Barricade by pressing power button OFF then ON.

It should have a new IP address provided by your ISP.

Hope it helps. Thank you for using FixYa.

You can get the driver here with some additional notes - the download option is near the bottom on the right hands side of the page - near the catchya image

Please vote kindly if this helped you

Default password for most of the modem is "admin"
If it doesn't help, then it will be mentioned in your modem user manual. For resetting your modem, you can use the hardware reset switch also. You can reset using that by inserting a small pin/needle into the hole located somewhere behind the modem.

No it is not ADSL 2+ compatible sorry! only ADSL but there is a lot of cheap ADSL2+ routers that work really well.
You can get firmware from HERE

just hardwired a computer to the router and open a web browser. on the address bar of the web browser type http://192.168.2.1 (default ip address of the router) and you will be prompted with the login screen. by default you don't need to type anything on the password field. now you will prompted with the router's page and from there you can set it up.
click here for the manual.

hope this'll help you

ciao

Hello, Not knowing the manufacture or model of router makes it hard to answer your question. You should be able to go to manufacture web site and do a search for your problem. You can also google the model # and maybe get an answer. Give me a model # and I'll try to help. Normally there is a reset hole on back. Thanks..

Connect the LAN port on the Barricade to the WAN port on your wireless router. The Barricade should be "plug-and-play",
i.e., no need to configure it. Similarly, the WAN port on the wireless-router is plug-and-play, so it should automatically get an IP-address from the Barricade.

Use an Ethernet cable to connect the network-port on your computer to one of the LAN ports on the router.
Then, start Internet Explorer, and connect to the web-server "inside" the router. Run the "Wired Network Setup Wizard", and then the "Wireless Network Setup Wizard". When you're done, then your "wireless" device(s) (iPod Touch, laptop, XBox360) should be able to make a wireless connection.

Note: no need for any CDs to "install" anything.