GE PROFILE ARTICA REFRIG. MADE A CLUNK NOISE AND I THOUGHT IT WENT OUT, BUT IT DOES SEEM TO STILL BE COOLING. WHAT CAUSES IT AND IT IS GOING TO BE TROUBLE FOR ME SOON??

WR55X10942 Main Control Board
WR55X10942 Main Control Board This sounds like motherboard failure. I am not sure what your model number is but that will be important should you have someone to help repair your refrigerator. These problems are common on the Artica Profile Models. I will be here to help you repair if you should choose, Thanks Sea Breeze

Hi, There can be many reasons why your refrigerator is freezingyour food. To see what could be happening and to figure out how to possibly fixyour problem. Take a look at this tip which contains many of the causes andsolutions to fix the problems.

Refrigeratoris Too Cold and Freezing Food
heatman101

Hi,

Its very difficult to suggest one single solution for this as there are couple of reasons for the issue. I would rather request you to check out this article which includes the reasons and troubleshooting steps for the same:

http://ars.samsung.com/customer/usa/jsp/faqs/faqs_view_us.jsp?SITE_ID=1&PG_ID=0&AT_ID=222860&PROD_SUB_ID=0&PROD_ID=823

Please let us know if you need any further clarification.

Thanks

This could be a relay on the control board or the compressor is short cycling or both. You can use my assistance to help you resolve this or call a technician, this depends on you. I am very familiar with the Artica/Profile and know that if you can follow instructions and use a test meter we can get this fixed. I would like your complete model number so I can refer to the exact model you have. I will leave you contact information and a service manual and a web page to use with the diagnostics. This problem will not get better, Sea Breeze

Your refrig display , has lost communication , with the main control board , located , behind the refrig , behind an 8 " X 10 " panel . The control board , is easily replaceable , with 7 or 8 plugs , attached to it . The part number , for your board , is WR55X10942 . It runs about $150.00 .

It is probably caused from one or more of the four rubber bushings that mount your compressor to the refrigerator frame. The bushings wear over time and causing the compressor bracket to have a little play. Then when the compressor stops it moves the frame slightly bumping against the mounting bolt causing a slight to moderate sounding clunk when stopping, Also check a lines and cords as a cord refrigeration line near the compressor or fram can also cause the problem.

Is the thermostat knob turned to the proper setting? If not, reset it.

Next, see if the compressor motor is running

The compressor is a football-sized case with no apparent moving parts. It's on the outside of the refrigerator at the back near the bottom. If it is humming or making a continuous noise and your refrigerator is still not cooling, there may be a more serious problem with one or more of several different components, we recommend contacting a qualified appliance repair technician for further help.

If the compressor is not running but you do have power to the refrigerator, there may be a problem with one or more of these:

• The compressor
  
  
• The Thermostat
  
  
• The overload, relay, or capacitor
  
  
• The defrost timer
  
  
• The condenser fan motor
  
  

Replace the cold control

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

is it the type of doors with the plastic snap on caps that cover the hinges, if so pop them off and unscrew, if it has an ice maker on the door its more complex, good luck

The main PCB at the back of the appliance has failed