When copying a book there are black inks in border

you need to contact Borders and talk to the support staff. there should be a phone number in your reader when you try to contact them.

you might try pulling out the black ink cartrige and putting it back in place

please follow the onscreen instructuions from the below mentioned URL and hopefully this should fix the problem
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00829344&cc=us&lc=en&dlc=en&product=3301296
if the issue is not solve follow the below step
print a test page from printer still the issue is not solve thy to make a copy then also the issue is not solve follow the below step

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00837561&cc=us&lc=en&dlc=en&product=3301296
if still the issue is not solve then call the hp toll free number
1800-474-6836 they will replace the printer if the warranty period is there.

hope your issue gets resolved

thanks
regards
hamid

You can't reset the ink level on all Canon Pixma printers.You need to turn off the function on printer to show the ink level.On your printer this happen with push consistently buttons for black copy (for turn of level on black cartridge) and color copy (for turn of level in color cartridge). The printer
shows empty cartridges but it will printing.

check black cartridge, toner or ink might have finished

the problem occurs mainly due to following reasons


clogged catridge head
*clean it using ammonia solvent

bad contact of catridge terminals
*clean the contacts of both catridge and catridge holder

this sounds like you have ink on the paper look inside and clean the paper feed rollers with denatured alcahol found at the local hardware store

This maybe your cleaning blade, your drum or the fuser unit....the best way to find out is to make a copy a to stop it before it's getting to the fuser unit ( that's the thing very hot). If you see your border it's your cleaning or drum...But when you replace a drum you must replace the cleaning blade to !


Hope it help !

I solved this problem but probably not what the printer manufacturer would recommend! The reason you are just getting grey is that the black ink cartridge is either empty or dried out from non use and only the color cartridge is working. I had the same problem after being away for 5 months. I put the printer cartridge in a bowl of warm water to disolve the dried out ink on the print pad. I dried off the cartridge with a soft cloth and then it worked perfectly.

This could be because of a defective valve.

DO NOT CLEAN THE PIEZO PH WITH ANY SOLUTION EXCEPT ORINIGNAL BROTHER INK!!!! OTHERWISE YOU WILL DEFENETLY DESTROY THE PH!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Try this:

Place new carts into machine and make sure thy are secured.

Press menu then start bk copy then fourtimes arrow up. machine will be in maintenance mode and lights will flash. press 7 then 6 then 4 then start bk copy. machine will refresh ink within tubes and ph and do some cleaning. when done press 7 then 6 then 3 then start bk copy. machine will do a power purge.
Leave maintenance afterwards by pressing 9 then 9. Do run a test print by pressing ink etc.
If you still cant see any yellow and/or magenta the ph is defective and needs replacement.