Printer light blinks grn and then yellow. No problem is given. Will not print. Error readout. Then cut off.

If the bottom amber colored light is blinking, the imaging drum needs replaced.

If the yellow print cartridge light is blinking, then replace the print cartridge (yellow toner).

Visite the support tech and try to find a answer for you probelem:

• here

one of the cartridges is dead and must be changed. buy new one and the problem will be solved.

Ready indicator Error indicator Condition Action
Green Orange
Blinking Blinking Communication Check The Printer
error cable
____________________________
Print over-run Turn off the printer.
After a few seconds
turn on the printer
change to a lower
resolution.
________________________________________________________



This may help if not...let me know........Whytfang

The yellow-print-cartridge
light is blinking, and the
printer stops printing.

The print cartridge is
empty or missing.

The printer cannot
detect the print
cartridge correctly.
1. Reinsert or replace the print cartridge.
2. If the print-cartridge light is still blinking but the
Attention light is not on, turn the printer off and
then back on.
3. If the problem persists, repeat the above steps
with yellow print cartridges until the error is
resolved.
4. If the problem persists, replace the printcartridge
E-label reader, which is located on the
pressure assembly of the print-cartridge
carousel.

hi!!!!

try to pull out the cardtridge and put it back properly
sometime the cartrigde is place properly on the printer!!!

try to email me [email protected]

My converted iP1200 is currently blinking green, yellow, green, yellow on the power lights after start up and print request. The pop-up prompt suggests turning off the printer and turning it back on. Error 5100 is always seen.

Please Help Me...

rakibfuture

The yellow blinking light is not reported in the code errors, take a look to service manual http://rapidshare.com/files/91114670/Canon_i550_i850_i950_Service_Manual.pdf.html
(hard to find but I did it ! )

I had the same problem and I solve it sending the clean head command from the settings of the printer driver (win XP)
I also reset the printer as it is explained in the service manual.

driver

You can try restoring the printer to factory settings..and try agian it has worked most of the times for me..Let the catridge be in the printer when you do this..