Tv got wet and won't turn on? If plugged in makes a squeaky sound

A squeaky sound coming from underneath your 2015 Nissan Versa Note, even with low mileage, can be worrisome. While it's difficult to pinpoint the exact problem without a physical inspection, I can suggest some potential causes based on your description and the symptoms:
Possible reasons:
Worn suspension bushings: These rubber parts connect various suspension components and can dry out or develop cracks over time, resulting in squeaking when they move.
Loose sway bar links: These control bars aid in stabilizing your car during turns and can become loose, leading to clunking or squeaking noises.
Loose or worn-out serpentine belt: This belt drives various accessories such as the alternator and power steering pump. When it's worn or loose, it can produce a squealing sound, particularly when starting or accelerating.
Dry or worn CV axle boots: These rubber boots protect the CV joints that transfer power to the wheels. If they are dry or torn, they can cause squeaking, especially during turns.

Additional information for diagnosis:
Does the squeaking occur consistently or intermittently?
Does the sound change in pitch or intensity when turning or braking?
Is there any noticeable vibration or pulling to one side while driving?
Have you observed any other changes in the car's handling or performance?
Recommendations:
Schedule a service appointment with a qualified mechanic: They can examine the suspension, brakes, and other potential sources of the noise and provide an accurate diagnosis.
Do not disregard the noise: Ignoring it could lead to more serious issues and costly repairs later on.
Gather any additional information you can: If the noise seems to occur under specific conditions, make a note of them to assist the mechanic in their diagnosis.
While your low mileage may suggest that the issue isn't significant, it's always best to have it checked by a professional. Early detection and repair can save you time, money, and potential safety risks in the future.

Likely dribbling injectors and/or bad spray patterns.

Many older fuel injected cars can sometimes get themselves into a sort of bad mood where for no apparent reason they fire briefly when the key is turned and then stop and further attempts at starting just wets the spark plugs.

Pulling out the fuel pump fuse and cranking with the throttle wide open will usually restore the engine to health until the next time.
I notice opening the throttle prior to starting does tend to overcome the problem, being careful not to over-rev the cold engine which means very quickly lifting off to a fast idle without actually lifting off altogether.

It sounds like you aren't getting a hot enough spark. Have you pulled out the spark plug and checked it?

First try to turn over the engine a few times.

Then immediately unplug the wire, use a socket to remove the plug, and check the end of the plug to see if its wet. If it is wet you are getting fuel, if it looks bone dry you aren't getting fuel and I can make some other recommendations.

Plug the wire back in and place the outside metal of the plug against the engine. When you try to crank the engine you will either see a nice spark or you won't.

Let me know what happens.

make v reset press the exit button on remote for more than 10 sec message reset will appear select yes tv will turn of turn tv back on and select home use this could repaire your problem

can someone tell me if a squeaky noise when I turn on my ac in my yukon, means the air compressor is going out? Please help!

check for vented caps or shorted flyback or tripler.

I think the ploblem should be the horizontal output that may be shot circuting working voltage,
apperently if you are not a qualify technician I recomend that you seek the help of such technician

sounds like the line output transistor is shorted look for a repair kit for your model

The sqeaky sound is arcing in the line timebase, or switch mode power supply, which also doubles up as the power supply for various voltages. You must get a service engineer to look at this as it will only get worse and cost more for repair if you continue to switch it on.

I'm having the same exact problem with mine! I'm looking for a solution also. I opened up the back of the TV and blew out the dust. Then I checked all connections. I put it back together and plugged it in. Now it doesn't make the high-pitched squeeking sound, but I still don't get a picture. My guess is the picture bulb is burnt out. I'm trying to find one online and am planning to fix it myself - wish me luck!