Will not spin in drain/spin cycle - Frigidaire ATF6000ES Front Load Washer

sounds like the transmission needs replaced

washing machine stopped mid cycle, won't drain : DIY - Reddit

https://www.reddit.com/.../washing_machine_stopped_mid_cycle_...

RedditSep 3, 2014 - helpwashing machine stopped mid cycle, won't drain (self.DIY). submitted 1 ... I get home. Any ideas on how I can just drain the water out of it?

Troubleshoot - washer stops mid cycle, won't drain or spin ...

? 1:58
https://www.youtube.com/watch?v=6Gc0ZgLD6a4
Jun 20, 2012 - Uploaded by searspartsdirect
Troubleshoot - washer stops mid cycle, won't drain or spin .... I agree, this was not helpful, and did not address the no spin issue. like thanks. ... how to fix a Kenmore / whirlpool washing machine that wont drain agitate or spin ...

Washing machine stops mid cycle - White Goods Help

www.whitegoodshelp.co.uk > ... > DIY Washing Machine Repair Help

Sep 9, 2013 - Possible causes when washing machine stops mid cycle by a ... If thewashing machine can't drain the water out then it will stick on the rinses, ...

Why does my washer stop half way through cycle - Ken

Quite often the problem with spin cycles is that the cycle cannot start until a sufficient amount of wash/rinse water has drained. So what will often happen is that the washer drains, the cycle starts, a lot of water comes out of the clothes, it stops, waits for the water to drain, then restarts. If the drain pump or drain lines are restricted or blocked or the pump is faulty, the unit may never achieve spin cycle.

Pcboard mulfunctioning

Sounds normal. Most machines do spit out a little water, rinse for a moment to loosen any trapped soap before they drain and spin.

Well your drain pump needs attention for sure. There could be an object lodged against propellers or it may need to be relaced. Try unplugging the connector that goes to the pump and plugging back in. Also try tapping the the motor part of the drain assembly while in spin cycle before replacing. Good luck.

your washing machine is overload or its timer is not working properly

If the timer advances normally thru the spin and drain steps of the cycle you selected, than the problem that would cause neither spinning or draining, is the wash motor is not reversing. The motors is a two direction motor. It spins clockwise for normal agitation, but counterclockwise to engage the wash drum clutch and operate the drain pump. I would ask you to check for motor sounds at all during the spin and drain cycles. The pump reversing in the spin or drain cycles can be a function of the machine's lid safety switch, or if not the motor switch or timer contacts. The lid switch is first thing to check here, for sure! If the machine seems to stop running when it comes time to drain or spin, the lid switch is your best bet!

Hope this helps.

kcomp1863

hello any spin problems could be down to the module circuit board all the best

shaun

timer contacts are burnt replace the timer