Canon Pixma MP130 Casing

Turn off printer.
Remove both the cartridges from the printer. Use a clothe moistened with alcohol to clean the surface contact on the cartridges where the terminals inside the printers touches.
Return the cartridges and turn on the printer.

Error 5100 means that the cartridge can not be detected by the printer.

Hope it helps!

1. Press the [Copy] button
2. Press the [Menu] button seven times ("USER DATA" or the equivalent will appear on the LCD)
3. Press the [+] button five times
4. Press the [OK] button
5. Press the [+] or [-] until "ENGLISH" or the equivalent (e.g., "ANGLAIS") appears on the LCD
6. Press the [OK] button
7. Press [Stop/Reset] to complete

there should be two screws holding it to the door panel could be concealed under a cover hope this helps regards Jim

Hi You can Try

Error Code 5100
Solution 1:
Clean the timing strip.

Solution 2:
The purge cap (the white sliding mechanism that the print head parks to when it's not in use) may be not lubricated well enough .

Lubricate the sliders with some white grease (don't get it on the small wipers or the black caps); this repair probably require to remove the right panel off of the printer to gain access to the purge mechanism.

All The Best: Pineworks

hmmm...i'd turn off the power first, then let it reset that way..

Hi You can Try have a go

Error Code 5100
Solution 1:
Clean the timing strip.

Solution 2:
The purge cap (the white sliding mechanism that the print head parks to when it's not in use) may be not lubricated well enough .

Lubricate the sliders with some white grease (don't get it on the small wipers or the black caps); this repair probably require to remove the right panel off of the printer to gain access to the purge mechanism.

All The Best: Pineworks

The cartridge seem to be jammed at the extreme right end of my machine. Pulled the ribbon to bring the cartridge slots to the centre. Then removed the cartridges. Unplug the power behind. After a minute, plug back the power. Load back the cartridges. Printer resumes back to working mode.

The control panel is fairly straight forward to get at.

Reove the stand from the tv, and lay the tv, screen down, on a flat surface. You should lay a cloth of some kind to prevent scratching to the casing.
Remove all the screws from the central metal plate on the back. You will need a torx T10 driver for these screws.

Carefully remove the plate. Note any cables which may be attached.

Remove the screws from the outer back casing and remove the casing.

The control panel is held in by two screws. Remove the screws and re-position the control panel. If the control panel is damaged it can be replaced.