...turning the handle upwards to open out the other deadlocks and slide locks, they work okay, but when I turn the key to engage the central deadlock, it wont budge. It means I can't use any of the ...
...tighten my top lock on the front door i can move my top lock with my hands from the iut side and when we turn the key it moves alot tighten the two screws on the inside of the door phillips ...
Question about B362 619 KA4 Dbl Cyl Deadbolt Per 004 Ea
...deadbolt, use a flat blade screw driver to turn the lock to the unlocked position while turning the knob and jiggling the door. If the key simply does not turn, the cap nut around the cylinder needs ...
Question about B362 619 KA4 Dbl Cyl Deadbolt Per 004 Ea
...deadbolt lock. The key works fine to open and close the lock but I can only remove it in the unlocked position. Also, the thumb side lock will not move unles the key is in the cylinder. Any ...
Question about B362 619 KA4 Dbl Cyl Deadbolt Per 004 Ea
deadbolt. I've also tried using the original key that came with the set and it still will not unlock or move. Kwikset Smart Key locks are complete junk. I am a locksmith and I am constantly going from
Question about B362 619 KA4 Dbl Cyl Deadbolt Per 004 Ea
...deadbolt on security door. If I try to lock/unlock from the inside, it works fine. From the outside, the key turns and turns but the bolt doesn't move. I am trying to remove the lock, but I don't see ...
Question about B362 605 KA4 DBL CYL DEADBOLT 4 EA 20536728
...key lock that goes through the deadbolt and into the manual knob. This bar turns with the key, sliding the bolt on its track to lock and unlock the door. Once the lock is apart check the key in the ...
...deadbolt is seized up. The reset key will not move at all in the lock. It is supposed to move 30 degrees to the left to reset the lock. It worked once. We have been using our front door that has ...
...move. can only lock and open with key. The deadbolt may very free inside the deadbolt hole... This system is low torque and a over torque clutch may slip if the dead bolt it's not completely free ...
move in the schlage deadbolt the key will not fully go into the lock but can be jiggled in after several tries. The lock worked fine this morning but I noticed when I got home the keyhole was slightly
Usually answered in minutes!
208 Questions
160 Questions
140 Questions
126 Questions