My kenmore 665.1376 has not been draining. i dont think it is finishing its cycles correctly. when i open the door, the bottom is full of soapy water. i have to wait a day, then hit the cancel/drain button, which does pump the water out. the water pumps out quickly, so it doesnt appear that any lines are clogged. Hope this is something i can solve myself.

I would put in some bleach and clothes that can handle it without damage and run a wash cycle. Leave the door open when you are done using the machine, or at least un-latched. There are commercial products, but bleach will do the same thing. You have stuff growing on the gizzards inside the drum, and bleach will likely kill them. They like dark & humid places.. guess what... that's your washer with the door kept latched.

sounds like the latch is worn out you mabe able to get a new one at appliancezone.com.... also check the drain for debris

Hi ii_goldie,What about the RINSE cycle... maybe the washer knows the "full cycle" is NOT finished.

The washer will display DONE... and make the door available to you. If not the cycle may not be finished. OR, turn it off, however, DON'T open the door if your machine has not drained all the water out, allow the system to finish.

clean pump and drain hose
thumbs up

it will not let you unlock the door because the machines full of water?--the machine will not finish its cycle because the vacume switch is still detecting water , The water will not drain because the pump is blocked with something , probably a wire from your underwire bra,all you can do is undo a pipe undernieth and let the water drain away and take the pump to bits ?There may be an inspection cap somewhere on the front at the bottom

sounds like a bad water inlet valve stuck open and permitting watertto enter even though not on, untill you replace the valve turn off water between uses part number 8181694

Our washer is flashing a F21 and it never finishes the load there is always water left.. what can we do to fix it?

Press "end of cycle" for over 3 seconds, & wait for 2 minutes to open door. You can then re-start the wash. It is possible you cld hv damaged fhe door switch. For front loaders you do not open the door during a wash, never. Less problems.

this is a necht dishwasher under one year old the problem is as follows. machine switche on make the normal noises to start with after about two minutes it beeps for about twenty seconds machine then stops. The water does not seem to be coming into the machine but a small amount of water does come in at the botom of the machine ie. where the waste is. Please can you help.
Thanks