Pc connection I couldn't get any signal from computer yet, how could I fix this?

The bulb? did you check both left side or just one?

The connections bad.... try rewiring the one for signal 2 or if its making a good connection... look for a weak spot in wire... that helped me when i couldn't figure out wiring

Hey sorry i do not have an answer for this but did you get this fixed. i had the alpine cde124xm since june 2011 and had xm activated for a year with no issues. however this sunday it started to happen i shut the car off it looses the signal and needs to be refreshed. Sorry to post this here but i couldn't find a way to contact your directly. Just wondering if you found a fix

HI there
I thought I was the only one who had movies inmy home I have friend come over for movies every wednesday.
Now there is a challange:
Try to ajust the brightness and contrast in the PICTURE menu
What the "no signal" concerns check if the signal cable is connected between the tv and products properly, as well as checking the selected input source by pressing input.
kolbrun

I formatted my computer dell dimension 4600c and now i can't get my windows to boot up it say strike f1 to retry boot, f2 for setup utiility

Check your SD card on the PC and if this is not detected then it is possible that the card is damaged. Unless the internal memory of the card is accessable by the PC , it cannot be formatted. If there is warranty claim for a replacement.

Good Day Dasarathi!

Please check the VGA cable if its properly connected and make sure two screws are fixed to both end connecting the monitor and the video card.

No signal comes out when there is no signal from the video card to the monitor. That is why you need to check if the VGA cable is fix to both end.

If that did not fix it, you will need to open the casing of your computer. Disconnect the video card from the motherboard. Gently clean by wiping a clean clothe over the contact surface of the video card. Then, reseat the video card properly to the slot in the motherboard. Return the casing cover and connect the VGA cable again.

Just remember doing the above procedure is only when the computer is turn off.

Turn on your PC and see if that fix it.

You will need to replace the video card if by booting the PC you will hear a series of beep codes. If no beeps then you are lucky VGA cable is the faulty one.

The cable connect the monitor to the computer you can check it by making sure it is connect properly,unplug it and then plug it back again because it may not be properly connected.

You try to boot the system with the in-built VGA card and not with your graphics card,then if any problem exist cotact me at my e-mail id : [email protected]

Ofcourse I can help you.