Conversion for Hayward H200 Ing Pool heater from propane to NG

I used to be able to get it through my supplier but the link is now dead and shows product not available. I am sure you can get this through Hayward direct. The last kit I bought was around $200 (my cost, not retail). As for a used kit, I seriously doubt that is an option.

all the parts needed will be in the kit. usually, its the control valve and the jets that get replaced. my manual shows its the same part all units. HAXCNK0002

???

What do you mean jump the terminals?

Not a good idea to ever jump anything, unless your are only troubleshooting!!!!

Especially on a natural gas fired heater! : -o

On this heater, the conversion may be a kit that replaces all the orifices. In any case if you call Hayward technical support they should be able to provide the correct solution. I hope this helps.

On this heater, the conversion may be a kit that replaces all the orifices. In any case if you call Hayward technical support they should be able to provide the correct solution. I hope this helps.

Yes you will need new orifices for propane. Part number IDX CNK 1933
http://www.haywardnet.com/inground/products/manuals.cfm
You should be able to get parts there too .

You didn't indicate your exact model. There are different versions of the H200 series. If it is milivolt then there is no electric, Must have correct milli-volt pilot generator. If it's electronic, check the air flow pressure switch on the combustion air.

flame sensor is probably dirty.remove and clean with fine steel wool.it is located near bottom of burner near ignitor

The p in the model means propane and you should also see a sticker on the gas valve that also says propane on it.

Big enough propane tank? proper pressure reducing valve on the propane? Check both of those.