Out of fuser web.I need to reset it on nwm.How I can do it ? Please help Mashine is xerox 5790

Hello, my name is Steve.

Keep in-mind that you still need to "Reset" the fuser's Image count.

Resetting this will start the process from "0".

Hope this helps,Steve

Seems like there are a lot of issues with this machine based on:
http://www.fixya.com/support/p2824428-xerox_workcentre_5765_5775_5790_fuser_mo
There appear to be several "experts" that may be able to help. I would look for other support, for example owner's manual and factory level troubleshooting support.
From the sound of it, there may be some kind of "jam" that is stalling the drive motor. Hopefully, you can find something that is causing the "stall" and then a way to "reset" the drive motor overheat protection that may be similar to larger motors with the red reset button.

Check all the paper detecting sensors once more, may be there is something over the sensor.clean all the sensors with VIDEO 90. if after that problem persist please restart the machine and go for software and firmware upgrades.
GOD BLESS YOU

Hello, The fuser or fuser roller is what actually bonds or melt the toner on to your paper. There is probably some type of temperature sensor, that senses the temperature of the fuser. If its not hot enough or just plain dead, it will give out an alarm similar to what your getting. You probably need to replace the fuser unit. You have a lower fuser and an upper fuser. You might be able to get away with just replacing the upper roller. The roller has a heating element inside and that's what probably defective.
Hope this Helps
Thank You for your feedback

please read the manual of this unit. if there is no manual please check on the xerox docucolor web site.

Hi there

10-342 Fuser Web Cartridge needs changing (this code should reset automatically when a new Web Cartridge is installed).

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks
Manually

that could be your fuser/youll maybe have to reset an nwm

Blown up thermal fuse inside the fuser assembly.It is quite dificult to replace it because you need to disassemble the entire fax mashine.It is a job for a trained technitian i'm afraid.

Wat is the code about this problem 08-300 its maine the Füser is not start on the same time when the cluts is not werking oder the pall is not gooing to this point open the front dore an you cann sche small cluts this is no good contact of its not working then you can puss the small wiel to the bik rol en the paper wil to the füser turn the green wiel and the paper go to füser out. I had this problem also with Xerox 5760 the same .

Try this,

Reset Fuser Life

1. Using the control panel buttons scroll to Maintenance, press OK.
   
2. Scroll to Check Others, press OK.
   
3. Scroll to Fuser, press Reset