- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
at this point it indicates a blockage in the pipes after the bottom pan
could be tree roots, waste, grease and fats from the kitchen /bath
try using a quality caustic soda product to destroy fats , waste and other organic material
other than that get in a plumber with a worm and cutter to remove build up/ roots from the pipe
if this problem is new in an established system it needs cleaning out but if is new in a new house , get a plumber to rectify the plumbing layout
wow what is error code 9 no crystal ball we need make and model to track an error code F9 any code F is always within the cycle
sounds like a bad pump too waist or its jammed with a cothes wires bits or a coin or perhaps the kids posted a plastic hotel or house a metal charicter or some wand or bit of a game too the soap drawer
so they are now in the filter
take out the objects
and flush the machine thru with a 1/2 load 30deg wash with no load
and let it all flush through
then clean the filter again
F9 is usually the water isnt being pumped out
or detected as pumped out
fast enough
Hi,
"Error A05 - Pressure switch has not been reset "
This is centered around the filter and drain area not working properly.
It is possible it just needs the filter cleaning and the hose flushing out, but also possible the pump needs to come out to clean it properly.
Drain it by putting the hose low down, and clean the filters of debris.
If this does not fix it, then remove the unit outside, lie on it's back and remove the pump to clean it.
Hello Sir, This error code, " F4 " comes only when the waste outlet is totally clogged with waste and blocked. Try to dismantle the machine and locate the Waste outlet pipe and thoroughly clean it. This will reset the error which is caused.
Set the controls to off then power off at the mains for 30 mins and then power mains back on and run a drain program or a full wash program. If the water won’t drain away then the most likely problems are the door interlock switch is faulty, the drain water motor is faulty, there is a blockage in the drain outlet pipe or filter – this will need unblocking, there is a blockage in the water pump – this will need to be unblocked, the controller board is faulty – but this generally shows an error code. First turn off the mains power to the dishwasher then check the internal filter and screen and clean it thoroughly. Then check the waste water hose and any outlet valve and make sure that it is unblocked and free of any obstruction or waste material. If you have access to the water pump you can check that it is free of obstruction and is able to turn and that none of the impeller vanes have been damaged. Then if all this is OK then try turning on the mains power and running a hot wash cleaning cycle to flush out any remaining sludge / debris.
×